Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: GM codes (4L60E family)

Code P1870: GM: transmission component slipping

GM's own codes on the 4L60E and its successors: the converter PWM solenoid (P1860) or a slipping component (P1870), almost always from valve body or converter clutch wear.

What's failing

GM codes (4L60E family)

Most common cause

The valve body

Can I drive with this code?

Better not to keep driving

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Harsh shifts, especially 1-2GM raises line pressure to maximum to protect the transmission when it detects slip.
  • Check engine light on; on some Isuzus and the 1996–1999 Honda Passport (US), the transmission light flashes
  • Slipping, no converter lockup or shudder on take-off
  • On 1996 GM trucks with the VCM computer1-2 or 2-3 slip or flare, or no 3rd and 4th.

Most common causes

  1. 1The valve bodyOn the 1996–2000 4L60E, the classic cause was wear where the converter clutch valves sit; the rebuilding industry still finds it in newer units.
  2. 2A clutch or the band slippingGM explains that slip of more than about 400 rpm at steady speed usually comes from there, not from the converter.
  3. 3A cracked converter clutch solenoid or a plugged orifice in the pump
  4. 4The converterWith 100 to 400 rpm of slip, GM points to its clutch not applying.
  5. 5On 1996 GM trucks with the VCM, a bad internal ground in the computer that commands erratic pressure; GM fixed it with a harness
  6. 6On a rebuilt 4T60-E, GM documented no converter lockup or surge with P0740 or P1870 after installation

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Is the fluid at the right level and in good condition, with no burnt smell?

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Is the fluid at the right level and in good condition, with no burnt smell?Yes: step 3 · No: step 2
  2. Step 2. Does the fluid smell burnt or have pieces of material in it?Yes: «Clutch or band: check inside» · No: «Correct the fluid level»
  3. Step 3. Is it a 1996 GM truck with the VCM computer?Yes: «Computer ground (VCM)» · No: step 4
  4. Step 4. Is there a new calibration for your VIN?Yes: «New calibration» · No: step 5
  5. Step 5. At the shop, is the line pressure OK when measured with a gauge?Yes: step 6 · No: «Pressure: valve body»
  6. Step 6. At a steady speed, does the scan tool show roughly 100 to 400 rpm of slip?Yes: «Converter clutch or its controls» · No: «Clutch or band: check inside»

Results

  • Clutch or band: check inside. Burnt fluid, pieces of material or more than about 400 rpm of slip point to a clutch or the band: the transmission needs repair. GM asks to flush the cooler and check its flow every time the transmission comes out.
  • Correct the fluid level. Set the right level with the fluid the carmaker specifies, clear the code and test again. If the code comes back, continue with this diagnosis: P1870 is a mechanical fault, and something is slipping.
  • Computer ground (VCM). On those 1996 trucks, GM fixed the computer's bad internal ground with a harness (bulletin 00-07-30-026, which also applies to the 4L60E). If the fluid is already oxidized or the slipping continues, the transmission needs repair.
  • New calibration. Ask for the calibration for your VIN and test again.
  • Pressure: valve body. Check the valve body: GM published how to recondition it on the 4L80E. Replacing only the valve body makes sense if the transmission worked fine when cold, the converter isn't blue from heat, the fluid isn't burnt and the pan has no debris.
  • Converter clutch or its controls. Check for valve body wear where the TCC valves sit (the classic cause on the 1996–2000 4L60E), a cracked TCC solenoid or a plugged orifice in the pump, and the converter last. Don't block the TCC regulator valve to clear the code: it ends up damaging the converter.
Diagnostic tip

Don't block the converter clutch regulator valve to kill the code: the rebuilding industry warns this sends full line pressure into the converter and ends up damaging it. On newer GM models, the same problem sets P0894.

Can I drive with this code?

Better not to keep driving: it's a mechanical fault and something is slipping. Get it to the shop with no load and as few miles as possible.

What carmaker bulletins say15 carmaker bulletins and the vehicles they nameShow

15 service bulletins published by the US NHTSA mention this code, mostly from Chevrolet, GMC, Oldsmobile, Pontiac, Buick (1990–2006 models).

Vehicles with service bulletins for this code

  • Chevrolet Express 1998–2004
  • GMC Savana 1999–2003
  • Chevrolet Corvette 1996–2005
  • Buick Roadmaster 1996
  • GMC GMC 1996–2002
  • Cadillac Escalade 1999–2000
  • Cadillac Fleetwood 1996
  • Buick Buick 2000–2002
Bulletin 030730001 · 2005
Chevrolet Trailblazer 2003 · GMC Envoy 2003 · Oldsmobile Bravada 2003

Transmission slipping or torque converter clutch (TCC) inoperative with no service engine soon light and no DTC P1870.

Open the bulletin (PDF) ↗
Bulletin 020730001A · 2004
Buick Buick 2000–2002 · Hummer H2 2003–2004 · Pontiac Pontiac 2000–2002 · Oldsmobile Oldsmobile 2000–2002

Diagnostic information on DTC P1870 (transmission component slipping) for passenger cars and light trucks.

Bulletin 3060 · 2004
Chevrolet Corvette 1996–2005 · Hummer H2 2003–2005 · Pontiac Gto 2004–2005 · Pontiac Firebird 1996–2002

4L60E/4L65E: the engine does not stall when running the P1870 test with the Tech 2 or commanding the TCC enable solenoid on applications without that test.

Bulletin 0405S001 · 2004
Isuzu Hombre 1997–2000

Harsh 1-2 upshift and MIL on with DTC P1870 set.

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 4L80E · 4T65E · 4L60E

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.