5L40E/5L50E: the cluster message center shows transmission over temperature, idle engine, with a possible DTC P0218.
Code P0218: Transmission fluid over temperature condition
The transmission fluid went over the maximum temperature the computer allows. It can be a clogged cooler, low fluid, a slipping converter, too much load or the sensor.
Transmission fluid over temperature
Low fluid level, or too much
Pull over somewhere safe and let it idle or shut it off until the temperature drops
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- A transmission hot message or warning on the dash (for example on the Aveo from 2018); GM warns from about 132 °C (270 °F)
- The transmission changes how it works to cool downChrysler activates an overheat shift schedule, and Mazda enters its protection control.
- Slipping or not shiftingGM documented it together with P0894 on 2006–2008 models (US).
- Check engine light on
Most common causes
- 1Low fluid level, or too muchMazda lists fluid above the specified level as a cause.
- 2A restricted or damaged cooler or cooler linesChrysler and Mazda list them as causes, and GM checks cooler flow.
- 3A stuck cooler thermostatic bypass valve (Chrysler)
- 4A converter clutch that doesn't apply or slipsChrysler lists it, and on 2006–2009 Chevrolet W trucks (US) GM found converter clutch friction material debonding.
- 5Driving habitsChrysler lists long periods idling in gear.
- 6An overheating engineGM first checks that engine coolant is below 125 °C.
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Is the engine running at its normal temperature, without overheating?
GM first checks that engine coolant is below 125 °C (257 °F): on many cars the transmission cooler is inside the radiator.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Is the engine running at its normal temperature, without overheating?Yes: step 2 · No: «The engine first»
- Step 2. Is the transmission fluid at the exact level, neither low nor overfilled, and the specified type?Yes: step 3 · No: «Correct the fluid level»
- Step 3. Did it overheat while towing, carrying a load, on long climbs, or idling a long time in gear?Yes: «Heavy use» · No: step 4
- Step 4. Are the cooler and its lines clear, not plugged, bent or kinked, and do they pass the flow test?Yes: step 5 · No: «Plugged cooler or lines»
- Step 5. Compared with a real measurement, is the temperature on the scan tool correct?Yes: step 6 · No: «Check the temperature sensor»
- Step 6. At the shop, does the converter lock up properly, without slipping?Yes: «Check the hydraulics» · No: «The converter slips»
Results
- The engine first. If the engine overheats, repair its cooling system first: GM asks to check that it works properly, because on many cars the transmission cooler is inside the radiator. Then clear the code and test again.
- Correct the fluid level. Set the exact level with the specified fluid: low or overfilled, the transmission overheats. Then clear the code and test again. Driving on while hot burns the fluid and the clutches.
- Heavy use. If the warning comes on, stop and let the engine idle in P or N until it goes out, as Ram advises. For towing or heavy loads an auxiliary cooler helps, but it won't fix a transmission that already slips or overheats from an internal fault.
- Plugged cooler or lines. Flush the cooler with shop equipment and the correct fluid, never with solvents, and measure the flow; if it's still low, replace it. Straighten or replace kinked lines and check the thermostatic valve, which Chrysler lists as sticking. After a catastrophic transmission failure, Chrysler asks to replace the cooler.
- Check the temperature sensor. If the scan tool temperature doesn't match the real one, the problem may be the sensor or its circuit, not the cooler: follow codes P0711 to P0713 in this tool.
- The converter slips. A converter that doesn't lock up or slips heats the transmission: on 2006–2009 Chevrolet W trucks (US), GM found the converter clutch friction material debonded. Repair it and flush the cooler, because the debris gets trapped there.
- Check the hydraulics. With the level, cooler, sensor and converter OK, check the hydraulics: on the 4L80E, a stuck converter valve or pressure regulator valve and an improperly seated pump seal are listed. GM notes the transmission can overheat with or without a code.
P0218 is the overheat code; P0711 is the temperature sensor, not the cooler. Each make has its own limit: GM sets it at 140 °C for 1 minute on the 6T70, Mazda at 135 °C for 10 seconds and Chrysler above 116 °C. Before replacing parts, check fluid level and condition and do a cooler flow test; after a catastrophic transmission failure, Chrysler asks to replace the cooler.
Pull over somewhere safe and let it idle or shut it off until the temperature drops; then drive gently and without a load to the shop. Driving hot burns the fluid and the clutches.
What carmaker bulletins say27 carmaker bulletins and the vehicles they nameShow
27 service bulletins published by the US NHTSA mention this code, mostly from RAM, Chevrolet, GMC, Saturn, Cadillac (2002–2024 models). The repair they mention most: updating the computer software.
Vehicles with service bulletins for this code
- RAM 3500 2016–2024
- RAM 2500 2016–2024
- Chevrolet Silverado 2006–2007
- GMC Sierra 2006–2007
- Cadillac SRX 2004
- GMC Yukon Xl 2500 2006–2007
- Buick Allure 2006–2008
- Chevrolet Express 1500 2006–2008
ECM/PCM reprogramming for a check engine light with diesel aftertreatment (SCR, NOx, DEF, particulate filter) and misfire DTCs.
Open the bulletin (PDF), page 3 ↗ECM/PCM reprogramming for a check engine light with diesel aftertreatment (SCR, NOx, DEF, particulate filter) and misfire DTCs.
Open the bulletin (PDF), page 3 ↗ECM/PCM reprogramming for a check engine light with EGR, turbo, air leak and diesel aftertreatment (SCR, NOx) DTCs.
Open the bulletin (PDF), page 3 ↗These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.
TSS parts for the transmissions in these bulletins
Sensor Velocidad ( Entrada 42rle ) ( Entrada Salida 45rfe 5-45rfe 68rfe )
FILTRO LIBERTY 4X2 45RFE
Filtro Solo GM Para Carter Bajo sin Espaciador en el Cuello Toma Plana 5L40E 5L50E
Filtro Bmw Carter Hondo con Espaciador en Cuello y GUIA en TOMA 1/2” 5L40E 4L40E 5L50E
Different transmission? Pick it and we'll show its parts:
Find the part by its number on the exploded diagram: 45RFE · 5L40E
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.