Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Transmission fluid temperature (TFT) sensor

Code P0711: Transmission fluid temperature sensor range/performance

A fault in the sensor that measures transmission fluid temperature or its circuit: no signal, an illogical one, or out of range.

What's failing

Transmission fluid temperature (TFT) sensor

Most common cause

Software

Can I drive with this code?

It can be driven carefully to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Harsh or delayed shiftsFord documented it on the 2017 F-150 with the 10-speed (US).
  • Different shifting when cold, because the computer uses a backup temperature
  • Limp mode on some unitsPer its manual, Ford's 6R80 stays in 1st or 3rd with the transmission light flashing.
  • Check engine light on

Most common causes

  1. 1SoftwareThe most documented fix in US bulletins: Ford reprograms the computer on the 2017 F-150 with the 10R80, Jeep and Fiat on the 2015–2016 Renegade and 2016 500X, and Subaru on the Ascent when it sets in cold weather.
  2. 2A reading that makes no senseFord's 6R80 sets it if the temperature stays below 21 °C (70 °F) or above 107 °C (225 °F), or barely changes; Nissan's JF015E CVT, if it doesn't change in 10 minutes of driving; Chrysler's 46RE, if it doesn't rise enough within 10 minutes of a cold start.
  3. 3An intermittent contact in the connector or wiring, including inside the transmission (internal harness or lead frame)
  4. 4The sensor; on GM's 6T40 and 6T70, the code sets when fluid temperature doesn't match the module temperature
  5. 5The computerKia lists it among the causes on its 6-speeds and says not to replace the transaxle.

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

From a cold start, does the fluid temperature on the scan tool rise as you drive, like the engine's, without freezing at one value?

Ford (6R80) sets P0711 if it stays below 21 °C (70 °F) or above 107 °C (225 °F), or barely changes; Nissan (JF015E CVT), if it doesn't change in 10 minutes of driving; Chrysler (46RE), if it doesn't rise enough within 10 minutes of a cold start.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. From a cold start, does the fluid temperature on the scan tool rise as you drive, like the engine's, without freezing at one value?Yes: step 2 · No: step 4
  2. Step 2. Is there a software update for your model?Yes: «Update the software» · No: step 3
  3. Step 3. With the scan tool connected, does the reading jump or drop out when you move the harness and connector?Yes: «Bad contact in the connector or wiring» · No: «The reading makes sense»
  4. Step 4. Is the transmission connector clean and tight, with no water, corrosion or pushed-out terminals?Yes: step 5 · No: «Bad contact in the connector or wiring»
  5. Step 5. Does the sensor's resistance match your transmission's temperature chart?Yes: step 6 · No: «The sensor, or the part that carries it»
  6. Step 6. Is the wiring to the computer OK, including inside the transmission (internal harness or lead frame)?Yes: «The computer, last» · No: «Bad contact in the connector or wiring»

Results

  • Update the software. Ask for the reflash for your model before replacing parts. In the US, Ford fixes it that way on the 2017 F-150 with the 10R80, Jeep and Fiat on the 2015–2016 Renegade and 2016 500X, and Subaru on the Ascent when it sets in cold weather.
  • Bad contact in the connector or wiring. Clean and repair the connector (water, corrosion, pushed-out terminals) or the damaged section of wire. The bad contact can also be inside the transmission, in the internal harness or lead frame. Then clear the code and test again.
  • The reading makes sense. Clear the code and see if it comes back. Note: P0711 isn't an overheating code (that's P0218), but if the sensor reads correctly and the temperature stays high, Ford says to diagnose overheating: check the fluid level and the cooler.
  • The sensor, or the part that carries it. It's rarely a separate part: depending on the unit it's in the internal harness, lead frame or range sensor; on the U340E, Toyota replaces the internal harness. On Kia 6-speeds, Kia says to replace the sensor, not the transaxle.
  • The computer, last. With the connector, wiring and sensor OK, the computer remains: Kia lists it among the causes on its 6-speeds, and says not to replace the transaxle. On GM's 6T70, the sensor is inside the transmission module.
Diagnostic tip

P0711 is not an overheating code (that's P0218). Compare fluid temperature with engine temperature on the scan tool from a cold start: if it doesn't rise or stays frozen, check the connector and sensor; if it behaves, look for a software update for your model before replacing parts.

Can I drive with this code?

It can be driven carefully to the shop: the circuit works, but the reading isn't believable, so the computer may change its strategy or hold the transmission in one gear.

What carmaker bulletins say58 carmaker bulletins and the vehicles they nameShow

58 service bulletins published by the US NHTSA mention this code, mostly from Jeep, RAM, Chrysler, Fiat, Ford (1995–2025 models). The repair they mention most: updating the computer software.

Vehicles with service bulletins for this code

  • Jeep Cherokee 2014–2015
  • RAM 3500 2013
  • RAM 2500 2013
  • Chrysler 200 2015
  • Jeep Renegade 2015–2016
  • Fiat 500x 2016
  • Fiat 500 2016
  • Ford F-150 2017
Bulletin TJ36807.1.0-2024-06-18 · 2024
Volvo Xc90mhev 2024–2025 · Volvo Xc60mhev 2024–2025 · Volvo Xc40mhev 2025 · Volvo V90ccmhev 2024–2025

Vehicle jerks and the TCM sets DTC P071164. Instruction: delete the DTC and release the car; a TCM software improvement was planned for Q4 2024.

Open the bulletin (PDF) ↗
Bulletin 16-141-23R · 2023
Subaru Ascent 2019–2023

New TCM reprogramming files for DTC P0711 (fluid temperature sensor A range/performance) detected at low ambient temperatures (around 32 °F / 0 °C).

Open the bulletin (PDF), page 2 ↗
Bulletin TSB18-2079 · 2018
Ford F-150 2017

Harsh or delayed shifts and/or MIL with P0711 in the TCM on the 10R80. Fix: reprogram the PCM with IDS or FJDS release 108.04 or higher.

Open the bulletin (PDF), page 1 ↗
Bulletin 21-042-17 · 2017
Jeep Renegade 2015–2016 · Fiat 500x 2016

TCM reprogramming for DTCs such as P0887, P061B, P072F, P0711, P1CC9, P1D98 or U0401, harsh 1-2 upshift, harsh garage shifts and CAN message dropout.

Open the bulletin (PDF), page 2 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for this code

Pick your transmission to see the TSS parts that fit it, or open all parts of this type:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.