Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Shift error

Code P0780: Shift malfunction

The computer commanded a shift that didn't happen as expected, or the shift timing solenoid fails. It can be a solenoid, the valve body, pressure or a clutch.

What's failing

Shift error

Most common cause

Valve body pressure switches sticking from contamination in their passage

Can I drive with this code?

Carefully and only to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Check engine and AT warning lights onMazda documented it on its Skyactiv models (Mazda3, Mazda6, CX-3, CX-5, CX-9), sometimes with P1738 and pressure switch codes.
  • A gear that won't engage or shifts in the wrong place
  • On the 2021 Rogue and 2022 Outlander (US), tied to the electronic shifter system

Most common causes

  1. 1Valve body pressure switches sticking from contamination in their passageOn Skyactiv units, Mazda fixes it by reprogramming the module or replacing the switch.
  2. 2The valve bodyOn the 2012–2013 Mazda3 Skyactiv (US), Mazda replaced it with a new pre-programmed valve body and required the initial learning procedure.
  3. 3Low fluid or the solenoidsMazda checks fluid level, the solenoids and the pressure switches.
  4. 4A mechanical problem in the hydraulic systemThat's how Honda defines it, and Honda also published information for P0780 appearing after a solenoid or transmission replacement (US).
  5. 5Software or the shift actuatorOn the 2021 Rogue (US), Nissan reprograms the transmission computer and the shifter module; on the 2022 Outlander, Mitsubishi says not to replace the transaxle if diagnosis points to the shift actuator, which is sold separately.

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Did the transmission module store another code besides P0780?

Save the freeze frame, clear the codes and do two road tests in D, going through every gear above 20 km/h (12 mph) for more than 20 seconds each: that's what Honda asks.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Did the transmission module store another code besides P0780?Yes: «Fix that code first» · No: step 2
  2. Step 2. Were solenoids or the transmission replaced shortly before the code appeared?Yes: «Check the solenoid connectors» · No: step 3
  3. Step 3. With the engine warm, is the fluid at the right level, with no leaks?Yes: step 4 · No: «Fix the fluid and the leak»
  4. Step 4. Draining the fluid through a strainer, does it come out free of metal debris and heavy clutch material?Yes: step 5 · No: «Internal wear»
  5. Step 5. Is there a software update for your model?Yes: «Update the software» · No: step 6
  6. Step 6. When you activate them with the scan tool, do all the shift solenoids click?Yes: step 7 · No: step 8
  7. Step 7. Do the shift solenoids and the linear solenoids measure within the manual's value?Yes: «Shift valve or valve body» · No: «Replace the failed solenoid»
  8. Step 8. Bench-tested, does the solenoid that didn't click work and measure correctly?Yes: «Solenoid harness» · No: «Replace the failed solenoid»

Results

  • Fix that code first. Honda asks to fix it first, and it usually says what to check: on Honda 4-cylinder 5-speeds, P0780 summarizes P1730–P1734, and on Mazda Skyactiv units it comes with P1738 or with codes from pressure switches stuck by dirt. Look it up in this tool and follow its diagnosis.
  • Check the solenoid connectors. Check the wire colors before connecting: with the connectors swapped, the transmission won't upshift or stays in 2nd. When installing a remanufactured transmission in the 2003 Accord V6, Honda also updates the computer's software.
  • Fix the fluid and the leak. Fix the leak and correct the level with the fluid the carmaker specifies: Honda asks for its own ATF only (DW-1). Then clear the code and do the road tests.
  • Internal wear. With metal debris or heavy clutch material in the strainer, Honda replaces the transmission instead of testing solenoids further: it's the exception to its rule of leaving that for last.
  • Update the software. Ask for the reflash for your VIN and then do the learning procedure the carmaker requires: Mazda runs the initial learning on its Skyactiv units. On the 2021 Rogue (US), Nissan reprograms the transmission computer and the shifter module.
  • Replace the failed solenoid. Replace the solenoid that measures out of spec or fails on the bench: on the Accord 2.4, Honda replaces linear solenoids B and C together. Check the wire colors when connecting, clear the code and do two road tests.
  • Solenoid harness. If a shift solenoid doesn't click with the scan tool but checks out on the bench, Honda replaces the solenoid harness. Then clear the code and do two road tests.
  • Shift valve or valve body. With the fluid, software and solenoids OK, Honda ends up, depending on the unit, at shift valve D, the lower valve body or the transmission. On the 2004–2005 Civic, the stall test in D decides between the lower valve body and the transmission.
Diagnostic tip

P0780 is general and often comes with other codes (solenoids, pressure switches or ratio) that tell you what to check. On Mazda Skyactiv units, look for a module reprogramming first before replacing switches or the valve body, and run the initial learning after any repair.

Can I drive with this code?

Carefully and only to the shop: depending on the unit, it may skip a shift or go into limp mode.

What carmaker bulletins say57 carmaker bulletins and the vehicles they nameShow

57 service bulletins published by the US NHTSA mention this code, mostly from Mazda, Jeep, Nissan, Honda, Jaguar (2000–2023 models). The repair they mention most: updating the computer software.

Vehicles with service bulletins for this code

  • Mazda Mazda3 2012–2018
  • Mazda Mazda6 2014–2021
  • Jeep Renegade 2019
  • Nissan Rogue 2021
  • Honda Odyssey 2001–2004
  • Jeep Cherokee 2019
  • Fiat 500x 2019
  • Honda Accord 2003–2004
Bulletin NTB22-093 · 2022
Nissan Rogue 2021

DTC P0780 (shift error) stored in the TCM, past or current. Confirm part numbers and reprogram the TCM and shift control module (SCM) if applicable.

Open the bulletin (PDF), page 2 ↗
Bulletin TIN-21-23-001 · 2021
Mitsubishi Outlander 2022

Clarifies CVT shifter and P0780 diagnosis: if it points to the shift actuator, DO NOT replace the transaxle; the shift actuator and inhibitor switch are sold separately.

Open the bulletin (PDF), page 1 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.