Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Torque converter clutch (TCC)

Code P0741: Torque converter clutch performance or stuck off

A fault in the torque converter clutch or its solenoid: it won't apply, it stays applied or its circuit fails. If it stays applied, the engine can shudder or stall when stopping.

What's failing

Torque converter clutch (TCC)

Most common cause

Low, degraded or wrong-spec fluid

Can I drive with this code?

It can be driven carefully to the shop, but if it shudders or slips, heat and converter debris can damage the rest of the transmission

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Shudder or vibration at steady highway speed, right when the converter should lock up
  • Higher than normal engine rpm on the highway and higher fuel use
  • Check engine light on; on some Hondas and Acuras, the D on the dash flashes
  • In some cases it slips or is slow to accelerateKia and Hyundai documented this on their IVTs with P0730, P0731 or P0741.

Most common causes

  1. 1Low, degraded or wrong-spec fluidFord checks level and condition first on the 6R80, and Chrysler warns that non-recommended fluid can cause converter shudder.
  2. 2The lockup solenoid and the lockup valves in the valve body, which wear; GM corrected 4T65-E and 4T40-E cases by reconditioning the valve body
  3. 3A leak in the converter apply circuitOn the 4F27E (Focus, Mazda 3), the rebuilding industry points to the pump stator bushings.
  4. 4Erratic speed sensors, which make the computer calculate slip that isn't there
  5. 5The converterHonda found cracked lockup pistons in the 2017 Odyssey, 2017–2018 Pilot and the Ridgeline (US), and Ford tied P0741 alone to internal converter damage on the 2013–2015 Escape 1.6 (US).
  6. 6SoftwareOn Kia and Hyundai IVTs (Forte, Soul, Seltos, 2020 Elantra), the first repair was a software update.

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Are there also speed sensor codes?

Erratic speed sensors make the computer calculate slip that isn't there.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Are there also speed sensor codes?Yes: «Fix the sensors first» · No: step 2
  2. Step 2. Are the fluid level and type what the carmaker specifies, and is the fluid in good condition?Yes: step 3 · No: «Correct the fluid»
  3. Step 3. Are the cooler lines clear, not crushed, plugged or kinked?Yes: step 4 · No: «Cooler lines»
  4. Step 4. Is there a software update for your VIN?Yes: «Update the software» · No: step 5
  5. Step 5. At the shop, are the lockup solenoid and the lockup valves in the valve body OK?Yes: step 6 · No: «Lockup solenoid or valves»
  6. Step 6. Is the converter apply circuit free of leaks, with its seals and bushings in good condition?Yes: «Now the converter» · No: «Leak in the converter circuit»

Results

  • Fix the sensors first. Fix the speed sensor codes first (they have their own page in this tool), then test lockup on the highway again.
  • Correct the fluid. Set the correct level and type, clear the code and road-test on the highway. If it shudders or slips, avoid highway driving and loads: heat and converter debris can damage the rest of the transmission.
  • Cooler lines. Repair or replace crushed, plugged or kinked lines and check the cooler. Then clear the code and road-test on the highway.
  • Update the software. Ask for the reflash for your VIN before replacing the converter, and road-test on the highway again.
  • Lockup solenoid or valves. They wear and come before the converter: on the 6R80, Ford checks the lockup solenoid and valves first, and GM fixed 4T65-E and 4T40-E cases by reconditioning the valve body.
  • Leak in the converter circuit. Repair the leak before replacing the converter: the turbine shaft seals, a plugged release orifice or, on the 4F27E, the pump stator bushings, which the rebuilding industry recommends replacing at every repair.
  • Now the converter. With the fluid, software, solenoid, valves and leaks ruled out, check the converter: Honda found cracked lockup pistons in the 2017 Odyssey, 2017–2018 Pilot and the Ridgeline (US), and Ford, with P0741 alone, internal converter damage on the 2013–2015 Escape 1.6 (US).
Diagnostic tip

It's a performance code, not an electrical one: Ford sets it when lockup fails to apply after three consecutive commands. Before replacing the converter, check fluid level and condition, fix any speed sensor codes first, and check the lockup solenoid and valves; Ford asks to finish that diagnosis before condemning the converter.

Can I drive with this code?

It can be driven carefully to the shop, but if it shudders or slips, heat and converter debris can damage the rest of the transmission: avoid highway driving and loads until it's fixed.

What carmaker bulletins say122 carmaker bulletins and the vehicles they nameShow

122 service bulletins published by the US NHTSA mention this code, mostly from Chevrolet, Hyundai, Ford, Audi, GMC (1993–2026 models).

Vehicles with service bulletins for this code

  • Audi Q5 2011–2014
  • Audi A8 2011–2013
  • Hyundai Elantra 1996–2020
  • GMC Savana 2008–2015
  • Nissan Kicks 2018–2021
  • Nissan Versa 2020–2021
  • Cadillac Deville 1993–2004
  • Chevrolet Express 2012–2015
Bulletin B23-029 · 2024
Acura RDX 2017–2018

The lock-up clutch cannot hold because pressure bleeds through a crack in the lock-up piston. The 'D' indicator flashes and DTC P0741 sets.

Open the bulletin (PDF), page 3 ↗
Bulletin A23-077 · 2023
Honda Odyssey 2017

Torque converters may not have been built to spec: a cracked lock-up piston keeps the lock-up clutch from holding. The 'D' indicator flashes and DTC P0741 sets.

Open the bulletin (PDF), page 3 ↗
Bulletin B23-029 · 2023
Acura RDX 2017–2018

The lock-up clutch cannot hold because pressure bleeds through a crack in the lock-up piston. The 'D' indicator flashes and DTC P0741 sets.

Open the bulletin (PDF), page 3 ↗
Bulletin A23-078 · 2023
Honda Pilot 2017–2018 · Honda Ridgeline 2017–2019

Torque converters may not have been built to spec: a cracked lock-up piston keeps the lock-up clutch from holding, which sets DTC P0741.

Open the bulletin (PDF), page 3 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 4T65E · 4T80E · 5L40E · 4L60E · 4R70W

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.