Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Torque converter clutch (TCC)

Code P0742: Torque converter clutch stuck on

A fault in the torque converter clutch or its solenoid: it won't apply, it stays applied or its circuit fails. If it stays applied, the engine can shudder or stall when stopping.

What's failing

Torque converter clutch (TCC)

Most common cause

Low or degraded fluid

Can I drive with this code?

Carefully and straight to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • The engine shudders or stalls when coming to a stop, because the converter stays lockedGM documented it on the 2013 Acadia, Enclave, Terrain and Traverse and on heavy-duty Silverado and Sierra trucks with the Allison (US).
  • Firm shifts, shudder, and no downshift on decelerationGM documented it on the 4T65-E in the Impala, Monte Carlo and Grand Prix.
  • Check engine light on; on the 4T65-E, GM raises line pressure to maximum and freezes shift adapts
  • On the Aveo, the engine stalls or shudders when stopping

Most common causes

  1. 1Low or degraded fluidMazda lists it along with the solenoids and the valve body.
  2. 2The lockup solenoid or its connectorOn the Aveo, fluid, connector and solenoid are checked before the converter.
  3. 3The lockup valves in the valve bodyGM published valve body reconditioning for the 4T65-E, 4T40-E and 4T45-E with P0741 and P0742, and the rebuilding industry points to wear in those valves.
  4. 4SoftwareOn the 2020 Altima (US), with only P0742 stored, Nissan reprograms the transmission computer.
  5. 5On the 4T65-E, a missing drive sprocket support bearing, per GM (US)
  6. 6Another system mistaken for the transmissionWith the Allison, GM asks to first isolate whether the stall at a stop comes from the transmission or the engine.

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

With lockup commanded off, does the scan tool show very low converter slip, as if it were still locked?

GM sets P0742 when slip is very low even though lockup is off. A typical symptom: the engine shudders or stalls when coming to a stop.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. With lockup commanded off, does the scan tool show very low converter slip, as if it were still locked?Yes: step 2 · No: «The converter releases now»
  2. Step 2. Is the fluid at the right level and in good condition?Yes: step 3 · No: «Correct the fluid»
  3. Step 3. Is the lockup solenoid connector clean and tight, with no damaged pins?Yes: step 4 · No: «Repair the connector»
  4. Step 4. Is there a software update for your VIN?Yes: «Update the software» · No: step 5
  5. Step 5. At the shop, does the lockup solenoid work and release properly?Yes: step 6 · No: «Stuck lockup solenoid»
  6. Step 6. Are the lockup valves in the valve body free, with no wear?Yes: «The converter, last» · No: «Lockup valves»

Results

  • The converter releases now. The fault may be intermittent or in another system: with the Allison, GM asks to first isolate whether the problem at a stop comes from the transmission or the engine. If the code comes back, check the fluid, connector and lockup solenoid.
  • Correct the fluid. Set the right level with the fluid the carmaker specifies, clear the code and test again. Meanwhile, drive carefully: if the engine stalls when stopping, you can lose the engine at a stop sign or in a turn.
  • Repair the connector. Clean or repair the lockup solenoid connector, clear the code and test again. On the Aveo, the fluid, connector and solenoid are checked before the converter.
  • Update the software. Ask for the reflash for your VIN and read the codes again afterwards.
  • Stuck lockup solenoid. Replace the lockup solenoid. On the 6T75 in the 2013 Acadia and Enclave, the solenoid is inside the module and stuck from debris: in the US, GM replaced the module on customer vehicles.
  • Lockup valves. Recondition or replace the valve body: GM published reconditioning for the 4T65-E, 4T40-E and 4T45-E with P0741 and P0742, and the rebuilding industry points to wear in those valves.
  • The converter, last. With the fluid, connector, software, solenoid and valves ruled out, check the converter and the mechanical side: on the 4T65-E, GM found a missing drive sprocket support bearing (US).
Diagnostic tip

On the scan tool, watch converter slip with lockup commanded off: GM sets P0742 when slip is very low even though lockup is off. Check fluid, connector and lockup solenoid before the converter, and look for software updates for your model.

Can I drive with this code?

Carefully and straight to the shop: if the engine stalls when stopping, you can lose the engine at a stop sign or in a turn.

What carmaker bulletins say36 carmaker bulletins and the vehicles they nameShow

36 service bulletins published by the US NHTSA mention this code, mostly from Chevrolet, Buick, Pontiac, Oldsmobile, Hyundai (1996–2021 models).

Vehicles with service bulletins for this code

  • Chevrolet Impala 2000–2014
  • Chevrolet Monte Carlo 2000–2007
  • Buick Rendezvous 2001–2007
  • Buick Regal 2000–2005
  • Hyundai Elantra 1996–2007
  • Hyundai Tiburon 1997–2008
  • Nissan Altima 2020
  • GMC Sierra 2001–2008
Bulletin NTB19-116B · 2021
Nissan Murano 2020 · Nissan Redundant Rogue Sport 2020–2021 · Nissan Altima 2020

MIL on with DTC P0742 stored in the TCM (amended bulletin; see the amendment history).

Open the bulletin (PDF), page 2 ↗
Bulletin NTB19-116 · 2019
Nissan Altima 2020

MIL on with only P0742 (torque converter), or P0742 with P187E, in the TCM. Confirm it applies and reprogram the TCM. Does not apply with other codes or an engine stall.

Open the bulletin (PDF), page 2 ↗
Bulletin PI0999 · 2013
GMC Acadia 2013 · Buick Enclave 2013 · GMC Terrain 2013 · Chevrolet Impala 2014

Preliminary information for MIL on, torque converter clutch sticking, engine shudder when stopping, and DTC P0742.

Open the bulletin (PDF), page 1 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 4T65E · 4T40E · 4L80E

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.