Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Speed sensors (input, turbine or output)

Code P0720: Output speed sensor circuit malfunction

The computer gets no signal, or an illogical one, from a transmission speed sensor. Without it, it doesn't know when to shift and usually goes into limp mode.

What's failing

Speed sensors (input, turbine or output)

Most common cause

The sensor connector

Can I drive with this code?

Only to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • The speedometer drops to 0 or moves erratically, and the odometer may show dashes
  • It won't upshift, starts off in a high gear or goes into limp modeThe 6R80 starts in 5th and the 4L60E stays in 2nd.
  • Harsh or mistimed shifts
  • Cruise control stops working, and on some trucks the ABS light also comes on because they share the signal

Most common causes

  1. 1The sensor connectorMoisture, corrosion or damaged pins (Nissan found this on its CVTs; Hyundai, poorly seated pins).
  2. 2The wires between the sensor and the computer, open or shorted
  3. 3The sensor tip and its tone ringStuck metal debris, damaged teeth, a loose ring or an incorrectly torqued sensor bolt (GM says the torque is critical).
  4. 4The output speed sensor itself
  5. 5The part that carries it on units with an internal sensorOn the 6R80 in the F-150, the molded lead frame, without replacing solenoids per Ford; on some Nissans, the valve body.
  6. 6Software or groundsMazda and Allison corrected cases that way.

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Driving at 16–32 km/h (10–20 mph), does the output speed on the scan tool rise and fall with the car's speed without dropping out?

That's GM's procedure. On many recent cars the speedometer reads the ABS speed, so it can't test this sensor.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Driving at 16–32 km/h (10–20 mph), does the output speed on the scan tool rise and fall with the car's speed without dropping out?Yes: step 2 · No: step 3
  2. Step 2. Does the code come back after you clear it?Yes: «Intermittent signal» · No: «The signal is good»
  3. Step 3. Is the sensor connector clean and tight, with no moisture, corrosion or damaged pins?Yes: step 4 · No: «Repair the connector»
  4. Step 4. Measured with a multimeter, are the wires between the sensor and the computer OK, with no opens or shorts, and does it get power if it's a Hall-effect sensor?Yes: step 5 · No: «Wires or power supply»
  5. Step 5. Is the sensor tip clean, with no metal debris, and the tone ring undamaged and tight?Yes: «Replace the output speed sensor» · No: «Debris or a damaged tone ring»

Results

  • The signal is good. If the reading rises and falls without dropping out and the code doesn't return, GM asks to stop testing so you don't replace parts needlessly. If it comes back, check the connector and wires.
  • Intermittent signal. Check for loose connections, debris on the sensor tip and the tightness of its bolt, which GM says is critical. Also look for software updates: Mazda and Allison fixed cases like this.
  • Repair the connector. Clean or repair the connector: Nissan found moisture and corrosion on the sensor pins of its CVTs, and Hyundai damaged or poorly seated pins. Then clear the code and test again.
  • Wires or power supply. Repair the open or shorted wire, or the missing power, before replacing the sensor.
  • Debris or a damaged tone ring. Clean the debris off the tip: it comes from wear inside the transmission, so check the fluid too. A tone ring with damaged teeth or play distorts the signal and is repaired inside the transmission.
  • Replace the output speed sensor. With the connector, wires and tip OK, the sensor is the suspect. On the 6R80 in the Lobo and F-150 it comes in the internal harness (lead frame), and on some Nissans in the valve body. Afterwards, GM asks to reset the transmission's adaptive learning.
Diagnostic tip

Watch output speed on the scan tool while driving at 10–20 mph: it must rise and fall with road speed without dropping out (GM procedure). Check the wires with a meter, not with the scan tool or speedometer, and remember many newer cars take the speedometer reading from the ABS.

Can I drive with this code?

Only to the shop: the transmission may stay in one gear or start off in a high gear. On 2011–2014 F-150s in the US, Ford recalled trucks because a fault in this sensor could downshift abruptly to first; if that happens, pull over.

What carmaker bulletins say15 carmaker bulletins and the vehicles they nameShow

15 service bulletins published by the US NHTSA mention this code, mostly from Ford, Mercury, Lincoln, Nissan, Hyundai (1999–2016 models). The repair they mention most: checking or replacing the sensor or switch.

Vehicles with service bulletins for this code

  • Ford Taurus 2000–2008
  • Ford Windstar 1999–2000
  • Nissan Rogue 2010–2014
  • Nissan Altima 2010
  • Lincoln MKX 2007–2008
  • Lincoln Navigator 1999–2013
  • Infiniti Q50 2014–2015
  • Hyundai Tucson 2005
Bulletin ITB19-040 · 2019
Infiniti Q50 2014–2015

MIL on with P0720 (output speed sensor), sometimes with harsh shifts or lack of power. If diagnosis calls for the sensor, replace the control valve (RE7R01A), not the sensor.

Open the bulletin (PDF), page 1 ↗
Bulletin NTB14019 · 2014
Nissan Rogue 2014

MIL with P2765, P0500, P1574, P1715 or P0720 plus moisture or corrosion at the secondary speed sensor pins. Dry the connector with electrical cleaner and replace that sensor.

Open the bulletin (PDF), page 1 ↗
Bulletin NTB-10-150 · 2013
Nissan Altima 2010 · Nissan Rogue 2010 · Nissan Sentra 2010

MIL on and/or slower than normal acceleration from a stop, more common after long highway driving, with DTC 01778 (step motor) and/or P0720 (output speed sensor).

Open the bulletin (PDF), page 2 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 6T70 · 6R80

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.