Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Transmission module power

Code P0888: TCM power relay sense circuit

The voltage reaching the transmission module is low, high or drops out. On Chrysler it's measured at the transmission relay output.

What's failing

Transmission module power

Most common cause

The battery and its terminals

Can I drive with this code?

Slowly and only to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Limp modeThe transmission stays in 2nd on Chrysler 4-speeds (41TE, 42RLE) or in 3rd on the 62TE.
  • Check engine light on; the fault is detected at key-on or right after cranking
  • P0846 or P0871 may set at the same timeChrysler says they don't indicate an internal fault and clear once P0888 is fixed.

Most common causes

  1. 1The battery and its terminalsOn the older version of this code (2000), the first cause Chrysler lists is low battery voltage.
  2. 2The transmission control relay or its connectors
  3. 3The relay's fused battery feed, open or with a voltage drop
  4. 4The output circuit to the solenoid packChrysler warns the circuits come from a common splice and asks to check it for corrosion or water.
  5. 5Fuse module (TIPM) codes and, last, the computer, after checking its terminals

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Are there fuse module (TIPM) or system voltage codes?

If P0846 or P0871 set with P0888, Chrysler says they don't indicate an internal fault and clear once it's fixed.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Are there fuse module (TIPM) or system voltage codes?Yes: «Fix those codes first» · No: step 2
  2. Step 2. Does the battery pass a load test, with clean, tight terminals?Yes: step 3 · No: «Battery first»
  3. Step 3. With another, known-good transmission control relay, does switched battery voltage stay steady around 12 V and the code not return?Yes: «It was the relay» · No: step 4
  4. Step 4. Is the relay's fused battery feed OK, with no open or voltage drop?Yes: step 5 · No: «Relay power feed»
  5. Step 5. Is the common splice of the output circuits to the solenoid pack clean, with no corrosion or water?Yes: «The computer, last» · No: «Corroded or wet splice»

Results

  • Fix those codes first. Fuse module or system voltage codes are fixed before P0888: look them up in this tool and follow their diagnosis.
  • Battery first. Tighten and clean the terminals, and charge or replace the battery, then clear the codes and test again.
  • It was the relay. If the voltage stays steady with the new relay and the code doesn't return, the transmission control relay was the fault: leave it in, clear the codes and run the verification test.
  • Relay power feed. Repair the fuse, the open wire or the voltage drop in the relay's feed; if the fuse had blown, find the short that blew it.
  • Corroded or wet splice. Clean or repair the splice and protect it, then clear the codes and test again before replacing parts.
  • The computer, last. With the battery, relay, feed and splice OK, check the computer's terminals and, last, the computer.
Diagnostic tip

It's the number Chryslers used from 2002 to 2008 (Voyager, PT Cruiser, Stratus, Liberty) for the same fault later called P0882: less than 3 V on the relay output. Swap the relay for a known-good one and watch switched battery voltage on the scan tool: if it stays steady around 12 V and the code doesn't return, the relay was the fault.

Can I drive with this code?

Slowly and only to the shop: the transmission doesn't shift in limp mode, and if the battery is the cause, the car may not restart.

TSS parts for this code

Pick your transmission to see the TSS parts that fit it, or open all parts of this type:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.