Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Transmission module power

Code P0890: TCM power relay sense circuit low

The voltage reaching the transmission module is low, high or drops out. On Chrysler it's measured at the transmission relay output.

What's failing

Transmission module power

Most common cause

On Chrysler, a pressure switch circuit (OD, 2/4, L/R and, on the 62TE, DC and LC) shorted to voltage

Can I drive with this code?

Slowly and only to the shop if the transmission is stuck in one gear

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • On 2002–2008 ChryslersLimp mode (2nd on the 4-speeds, 3rd on the 62TE), and the check engine light comes on after about 10 seconds of driving.
  • The fault is checked once at key-on or cranking, so it shows up from startup
  • On the 2019–2024 Subaru Outback, Legacy and Ascent (US), check engine light with the code detected by the engine computer

Most common causes

  1. 1On Chrysler, a pressure switch circuit (OD, 2/4, L/R and, on the 62TE, DC and LC) shorted to voltageThe code sets if any reads more than 4.5 V before the relay is energized.
  2. 2A chafed harness or a wet or corroded connector shorting those wires to a voltage source
  3. 3SoftwareOn Subaru (US), the name is "TCM power relay sense circuit low" and it was fixed with a reflash.
  4. 4The computer, last, after checking the wiring

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Are the transmission harness and connectors OK, with no chafing, water or corrosion?

On Chrysler, a chafed harness or a wet or corroded connector can short the pressure switch wires to a voltage source.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Are the transmission harness and connectors OK, with no chafing, water or corrosion?Yes: step 2 · No: «Repair the harness or connector»
  2. Step 2. Is there a reflash for your model?Yes: «Update the software» · No: step 3
  3. Step 3. Is your car a Chrysler, Dodge, Jeep or Ram?Yes: step 4 · No: «The computer, last»
  4. Step 4. With the computer and solenoid pack unplugged and the relay output activated with the scan tool, do all the pressure switch signals read 0.5 V or less?Yes: «The computer, last» · No: «Signal shorted to voltage»

Results

  • Repair the harness or connector. Repair the chafe or the wet or corroded connector before replacing parts, then clear the code and test again.
  • Update the software. Ask the dealer for the reflash for your VIN, then clear the code and test again.
  • Signal shorted to voltage. The signal above 0.5 V is the one shorted to voltage: trace that wire and repair the chafe or the connector before replacing the computer.
  • The computer, last. With the wiring OK, check the computer's terminals and, last, the computer.
Diagnostic tip

Chrysler calls it "switched battery", and it doesn't mean the same as on other makes. On the 62TE, with the computer and solenoid pack unplugged, Chrysler activates the relay output with the scan tool and measures each pressure switch signal: the one above 0.5 V is the one shorted to voltage.

Can I drive with this code?

Slowly and only to the shop if the transmission is stuck in one gear; a harness short can get worse with movement.

What carmaker bulletins say1 carmaker bulletin and the vehicles they nameShow

1 service bulletin published by the US NHTSA mention this code, mostly from Subaru (2019–2024 models).

Vehicles with service bulletins for this code

  • Subaru Outback 2020–2024
  • Subaru Ascent 2019–2024
Bulletin 09-117-24 · 2024
Subaru Outback 2020–2024 · Subaru Ascent 2019–2024 · Subaru Legacy 2020–2024

New reprogramming files to address DTC P0890 (TCM power relay sense circuit low) detected by the ECM.

Open the bulletin (PDF), page 3 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for this code

Pick your transmission to see the TSS parts that fit it, or open all parts of this type:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.