Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Incorrect gear ratio (slipping)

Code P0732: Gear 2 incorrect ratio

The computer compares input and output speed and they don't match the gear it commanded: the transmission slips in that gear. It's almost always a worn clutch or band, low pressure, a solenoid or the valve body.

What's failing

Incorrect gear ratio (slipping)

Most common cause

Low or degraded fluid.

Can I drive with this code?

Only as far as the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Slips in secondThe 1-2 shift drags out, the engine flares or it engages with a bang.
  • No 2nd gear (and on some units no 5th either), or the problem gets worse when the transmission is hot
  • Limp mode, or the transmission warning light flashing on Fords
  • Converter shudderChrysler documented P0732 with shudder on 2007 models (Liberty, Wrangler, Ram 1500, Durango) that was fixed with a reflash.

Most common causes

  1. 1Low or degraded fluid
  2. 2The input or output speed sensors or their harness
  3. 3Low pressurePump, valve body, a sticking valve or a solenoid that isn't working right.
  4. 4The part that makes 2nd in your unitOn the Explorer's 5R55W, the overdrive band (often from wear of the servo pin bore); on the Focus 4F27E, the 2-4 band; on the 6R80, clutch A or C; on the 62TE, Chrysler checks the UD, L/R and DC clutches.
  5. 5Software or mismatched tire sizes, which Chrysler documented in the US

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Are other codes stored, such as speed sensor, pressure or solenoid codes?

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Are other codes stored, such as speed sensor, pressure or solenoid codes?Yes: «Fix the other codes first» · No: step 2
  2. Step 2. Is the fluid at the right level and in good condition, with no burnt smell?Yes: step 4 · No: step 3
  3. Step 3. Does the fluid have metal debris or a lot of clutch material?Yes: «Internal wear» · No: «Correct the fluid»
  4. Step 4. On the scan tool, are the input and output speed sensor signals good?Yes: step 5 · No: «Speed sensors»
  5. Step 5. Are all four tires the same size?Yes: step 6 · No: «Match the tires»
  6. Step 6. Is there a software update for your VIN?Yes: «Update the software» · No: step 7
  7. Step 7. At the shop, are the line pressure and the 2nd-gear clutch or band pressure OK?Yes: «The part that makes 2nd gear» · No: «Low pressure»

Results

  • Fix the other codes first. Ford, Toyota, Honda and Chrysler ask for that: speed sensor, pressure or solenoid codes are fixed first. Look them up in this tool, follow their diagnosis and then test again.
  • Correct the fluid. Set the right level with the fluid the carmaker specifies and find the leak; Mazda lists low or degraded fluid first. Then clear the code and road-test.
  • Internal wear. Metal or clutch material in the fluid means internal wear: the transmission needs repair, and an additive or a fluid change won't fix it.
  • Speed sensors. A bad input or output signal mimics slipping: check the sensors, their connectors and the harness before opening the transmission.
  • Match the tires. Fit four tires of the same size, clear the code and road-test.
  • Update the software. Ask for the reflash for your VIN, especially if there's shudder too, as on those 2007 Chrysler models. Then clear the code and road-test.
  • Low pressure. Check the pump, the valve body, a sticking valve or a solenoid that isn't working right: Nissan points out these codes come from a mechanical fault, not an electrical one. On 5R55E, 4R44E and A4LD units built before December 2001, Ford linked P0732 to low line pressure.
  • The part that makes 2nd gear. If the pressure is good and it slips in 2nd, it's that gear's clutch or band: on the 6R80, A or C; on the 4F27E, the 2-4 band (with P0734); on the 5R55W, the overdrive band (with P0735), often from servo bore wear; on the 62TE, the compounder's DC clutch (with P0735); on Honda 5-speeds, the 2nd clutch.
Diagnostic tip

Look at which other ratio codes are set: on the 5R55W, P0732 with P0735 points to the overdrive band, which works in 2nd and 5th; on the 4F27E, P0732 with P0734 to the 2-4 band; on the 62TE, P0732 with P0735 to the DC clutch. Fix any speed sensor, pressure or solenoid codes first.

Can I drive with this code?

Only as far as the shop: if the band or clutch is slipping, every mile burns it further, and the transmission may stay in one gear.

What carmaker bulletins say60 carmaker bulletins and the vehicles they nameShow

60 service bulletins published by the US NHTSA mention this code, mostly from Ford, Lincoln, Chevrolet, GMC, Mercury (1994–2024 models). The repair they mention most: updating the computer software.

Vehicles with service bulletins for this code

  • Ford F-150 2017–2023
  • Ford Explorer 1995–2023
  • Lincoln Navigator 2018–2023
  • Lincoln Aviator 2020–2023
  • Chevrolet Silverado 2001–2014
  • GMC Sierra 2001–2014
  • GMC Sierra Denali 2003–2015
  • Chevrolet Silverado 2500 2001–2019
Bulletin 21-015-22 · 2022
Jeep Wrangler 2021

TCM reprogramming for MIL with U0293-00, P0732-00 or P061B-00; improves the 2-1 downshift. The HCP, AHCP (PIM), PCM, BPCM and IDCM must also be updated for it to work.

Open the bulletin (PDF), page 2 ↗
Bulletin 21-028-21 · 2021
Jeep Wrangler 2021

TCM reprogramming for MIL with U0293-00, P0732-00 or P061B-00; improves the 2-1 downshift. The HCP, AHCP (PIM), PCM, BPCM and IDCM must also be updated for it to work.

Open the bulletin (PDF), page 2 ↗
Bulletin 21-008-21 · 2021
Chrysler Pacifica 2017

TCM reprogramming for DTCs such as P0732, P0887, P1B13, P1DCD, U0103, P1CC9 or P1DDE, harsh upshifts (1-2 to 4-5) and a harsh coast downshift near a stop.

Open the bulletin (PDF), page 2 ↗
Bulletin 2100821 · 2021
Chrysler Pacifica 2017

TCM reprogramming for DTCs such as P0732, P0887, P1B13, P1DCD, U0103, P1CC9 or P1DDE, harsh upshifts (1-2 to 4-5) and a harsh coast downshift near a stop.

Open the bulletin (PDF), page 2 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 4T80E · CD4E

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.