MIL on with DTC P07457F (pressure control solenoid A stuck off) and/or harsh engagement into Drive. The ECM/PCM logic was updated; follow the repair procedure.
Open the bulletin (PDF), page 5 ↗Code P0745: Pressure control solenoid A malfunction
A fault in a pressure control solenoid (A, B or C) or its circuit: open, shorted, stuck or out of range. It causes harsh or soft shifts and often puts the transmission in limp mode.
Pressure control solenoid
A broken or shorted wire, or a loose, dirty or wet connector
Only as far as the shop
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- Harsh engagements into D or R and harsh shiftsOn many units, the solenoid gives maximum pressure with no current (Nissan turns it off on purpose so the car can be driven).
- Limp modeOn the 4-speed Versa, March and Tiida (RE4F03B), the transmission stays in 3rd.
- On the Mazda3 (2004–2013) the AT warning light comes on, but not the check engine light on the first trip
- Check engine or transmission light on
Most common causes
- 1A broken or shorted wire, or a loose, dirty or wet connectorNissan lists the harness and connector first.
- 2The coil of pressure control solenoid A, which varies by makeOn Nissan, Mitsubishi and Mazda it's the line pressure solenoid; on the Hyundai/Kia A4AF3 (Dodge Verna and Attitude up to 2011, Mexico), PCSV A.
- 3On Honda 4-speeds and Ford's 5R55W it's a hydraulic code, not an electrical oneFord describes it as an incorrect shift pattern from a mechanical or hydraulic failure, and Honda replaces linear solenoid A and, if it persists, the transmission.
- 4The valve bodyOn the RE5R05A in the Frontier V6 and Pathfinder, Nissan checks the regulator valve if line pressure is off.
- 5The computer, last
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Is your transmission a Honda 4-speed or the Explorer's 5R55W?
On those, P0745 isn't electrical but hydraulic: Ford describes it as an incorrect shift pattern from a mechanical or hydraulic failure.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Is your transmission a Honda 4-speed or the Explorer's 5R55W?Yes: «Hydraulic fault» · No: step 2
- Step 2. Are the harness and transmission connector OK, with no broken or shorted wires, and the connector clean, tight and dry?Yes: step 3 · No: «Wire or connector»
- Step 3. Measured at the transmission connector, is the solenoid coil within that transmission's value?Yes: step 4 · No: «Replace pressure control solenoid A»
- Step 4. At the shop, is the line pressure OK when measured with a gauge?Yes: «The computer, last» · No: «Line pressure or valve body»
Results
- Hydraulic fault. On Honda 4-speeds, Honda replaces linear solenoid A and, if it persists, the transmission. On the 5R55W, Ford ties it to an incorrect shift pattern: on the 2002 Explorer built before March 2002, it showed up with P0733 and no 3rd gear.
- Wire or connector. Repair the broken or shorted wire, or clean and secure the loose, dirty or wet connector. Then clear the code and test again.
- Replace pressure control solenoid A. With the coil out of range, the problem is the solenoid or its wiring inside the transmission. Which one it is depends on the make: on Nissan, Mitsubishi and Mazda, the line pressure solenoid; on the A4AF3 (Dodge Verna and Attitude up to 2011), PCSV A.
- Line pressure or valve body. If the coil and wiring are fine but the pressure is off, check the valve body: on the RE5R05A in the Frontier V6 and Pathfinder, Nissan checks the regulator valve.
- The computer, last. With the wiring, coil and line pressure OK, check the computer, always last.
Measure the coil from the case connector against that unit's spec: Nissan gives 2.5–5 Ω for the RE4F03B line pressure solenoid, and Hyundai 2.7–3.4 Ω at 20 °C (68 °F) for PCSV A on the A4AF3. If the coil and wiring are good, check line pressure with a gauge before blaming the valve body.
Only as far as the shop: with maximum pressure the engagements hit hard, and the computer may leave you in a single gear.
What carmaker bulletins say8 carmaker bulletins and the vehicles they nameShow
8 service bulletins published by the US NHTSA mention this code, mostly from Toyota, Lexus, Hyundai, Mercury, Ford (1996–2024 models).
Vehicles with service bulletins for this code
- Toyota Highlander 2017–2018
- Toyota Sienna 2017–2018
- Lexus Rx350 2019
- Lexus Rc 350 2019
- Ford Explorer 2002
- Hyundai Accent 1996–2004
- Hyundai Elantra 1996–2000
MIL on with DTC P07457F (pressure control solenoid A stuck off) and/or harsh engagement into Drive. The ECM/PCM logic was updated; follow the repair procedure.
Open the bulletin (PDF), page 5 ↗MIL with torque converter (P07407F) and stuck pressure control solenoid A, C, L, D, G or H DTCs. Replace the transmission and torque converter; on the hybrid, the hybrid module too.
Open the bulletin (PDF), page 1 ↗These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.
TSS parts for the transmissions in these bulletins
Kit Reparacion Conector Arnes 5R55W 5R55S
CAJA DE SOLENOIDES FORD 2004/UP RETRO 2002 5R55W 5R55S OEM 4L2Z-7G391-AA
Different transmission? Pick it and we'll show its parts:
Find the part by its number on the exploded diagram: 5R55W
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.