'Transmission fault - traction reduced' with P1889-14 or P0961-62 in the rear differential module (RDCM), from an oversensitive diagnostic flagging false faults. The RDCM is configured.
Open the bulletin (PDF), page 1 ↗Code P0961: Pressure control solenoid A control circuit range/performance
A fault in a pressure control solenoid (A, B or C) or its circuit: open, shorted, stuck or out of range. It causes harsh or soft shifts and often puts the transmission in limp mode.
Pressure control solenoid
Voltage and grounds
It can be driven to the shop, but with maximum pressure engagements hit hard, and with low pressure the transmission can slip
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- Harsh shiftsOn several GM units, with this code the computer raises line pressure to maximum.
- On the 4L60E (Silverado, Tahoe, Suburban), GM doesn't turn on the check engine light for this codeThere can be hard shifts with no light.
- On Ford's 6R80 (F-150), the opposite can happenMinimum line pressure from an intermittent short.
- Erratic shiftingOn Express and Savana vans with the 6L90 (US), together with P0965, P0969 or P2762.
Most common causes
- 1Voltage and groundsOn Express and Savana vans (US), GM found these codes together from a bad battery ground, and on the 4L60E it says the code can set with low voltage under high electrical demand.
- 2The pressure control solenoid wiring or connector, with an intermittent contact
- 3The pressure control solenoidOn the 4L60E, GM specifies 3 to 7 ohms at the transmission connector.
- 4On the 6L80, GM sets it when actual pressure doesn't match commanded pressure, so the fluid and hydraulics also count
- 5On the Cruze, Sonic and Trax with the 6T40, the solenoid is inside the transmission module and GM doesn't sell it separately
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Are several pressure solenoid codes set at the same time, such as P0965 or P0969?
If so, suspect something they share, not three solenoids: on Express and Savana vans with the 6L90 (US), GM found them together from a bad battery ground.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Are several pressure solenoid codes set at the same time, such as P0965 or P0969?Yes: «Voltage and grounds» · No: step 2
- Step 2. Are the charging voltage and the battery and engine grounds OK?Yes: step 3 · No: «Voltage and grounds»
- Step 3. With the scan tool connected, does the code or the pressure change when you move the harness and connector?Yes: «Bad contact» · No: step 4
- Step 4. Measured at the transmission connector, is the solenoid within the manual's value?Yes: step 5 · No: «Pressure control solenoid»
- Step 5. At the shop, is the line pressure OK when measured with a gauge?Yes: «The computer, last» · No: «Fluid and hydraulics»
Results
- Voltage and grounds. Fix the charging, the battery and the battery and engine grounds before replacing solenoids: GM found P0961, P0965 and P0969 together from a bad battery ground. Then clear the codes and test again.
- Bad contact. If it changes when you move the harness, that's where the fault is: repair the connector or the section with the bad contact. On the 6R80, an intermittent short can drop pressure to minimum.
- Pressure control solenoid. Replace the pressure control solenoid or the part that carries it: on the 6T40 it's inside the transmission module.
- Fluid and hydraulics. If actual pressure isn't what was commanded, check fluid level and condition and the valve body before replacing the solenoid.
- The computer, last. With the voltage, wiring, solenoid and pressure OK, check the computer, always last.
Before replacing the solenoid, check charging voltage and the battery and engine grounds: GM found P0961, P0965 and P0969 together from a bad ground. If several pressure solenoid codes set at once, suspect something they share, not three solenoids.
It can be driven to the shop, but with maximum pressure engagements hit hard, and with low pressure the transmission can slip: don't put it off.
What carmaker bulletins say3 carmaker bulletins and the vehicles they nameShow
3 service bulletins published by the US NHTSA mention this code, mostly from Land Rover, GMC, Chevrolet (2009–2015 models).
Vehicles with service bulletins for this code
- GMC Savana 2011–2012
- Chevrolet Express 2011–2012
Erratic shifting and MIL on, with DTCs P0961, P0965, P0969 or P2762 as history or active.
Open the bulletin (PDF), page 1 ↗These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.
TSS parts for this code
Pick your transmission to see the TSS parts that fit it, or open all parts of this type:
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.