Closes the engineering information request on vehicles that will not move in Drive, Neutral and/or Reverse with DTCs P0746 and P0747.
Open the bulletin (PDF), page 1 ↗Code P0746: Pressure control solenoid A performance or stuck off
A fault in a pressure control solenoid (A, B or C) or its circuit: open, shorted, stuck or out of range. It causes harsh or soft shifts and often puts the transmission in limp mode.
Pressure control solenoid
Low or damaged fluid
Only as far as the shop
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- Harsh engagement into D or R and harsh shifts, or the oppositeSlipping and lack of power, depending on where the pressure ended up.
- On Nissan, Jeep and Mitsubishi CVTsSluggish take-off, no acceleration or road speed won't build, and Nissan stops locking the converter.
- It stays in one gear or some gears are missing
- Check engine or transmission warning light on
Most common causes
- 1Low or damaged fluidHonda asks to check it for metal or clutch material.
- 2Debris or wear in the valve bodyToyota checks for debris in the valves after the solenoid, and on the 4R70W bore wear loses pressure when hot even after a new solenoid.
- 3Pressure control solenoid A, which varies by makeOn Nissan it's the line pressure solenoid; on Toyota, SL1; on Honda 5-speeds, linear solenoid A.
- 4Pressure sensorsOn the 2019 Malibu CVT (US), GM found P0746 caused by failed pressure sensors.
- 5On Nissan CVTs, low pressure pushes the pulley ratio out of rangeNissan removes the valve body and inspects the belt; if it didn't slip, it replaces only the valve body, and if it did, the CVT.
- 6SoftwareOn the 2013–2017 Sentra (US), Nissan reprograms the transmission computer when this code is stored, before inspecting the belt.
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Are other codes stored?
Toyota, GM and Ford ask to fix the other codes first, and Mitsubishi checks the CAN network beforehand.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Are other codes stored?Yes: «Fix the other codes first» · No: step 2
- Step 2. Is the fluid at the right level and in good condition, with no metal or clutch material?Yes: step 3 · No: «Correct the fluid»
- Step 3. Is it a Nissan CVT?Yes: step 4 · No: step 5
- Step 4. Is there a reflash for your VIN?Yes: «Update the software» · No: «Inspect the CVT belt»
- Step 5. At the shop, is the line pressure OK when measured with a gauge?Yes: step 6 · No: «Pressure out of range»
- Step 6. Does the solenoid pass the scan tool's active test, with its resistance within the manual's value?Yes: «Valve body» · No: «Replace pressure control solenoid A»
Results
- Fix the other codes first. Deal with the other codes first (look them up in this tool) and test again: on the U660E and U760E, Toyota warns that a single stuck solenoid can set codes for several.
- Correct the fluid. Set the right level with the fluid the carmaker specifies. If it has metal or a lot of clutch material, the transmission needs an inside inspection: in that case, Honda replaces the transmission.
- Update the software. Ask for the reflash for your VIN and test again before inspecting the belt.
- Inspect the CVT belt. On Nissan CVTs, low pressure pushes the pulley ratio out of range. Nissan doesn't sell the solenoid separately: it removes the valve body and inspects the belt; if it didn't slip, it replaces only the valve body, and if it did, the belt and pulleys or the whole CVT (US).
- Pressure out of range. Check the valve body: on the 4R70W, bore wear loses pressure when hot even after a new solenoid. On the 2019 Malibu CVT (US), GM found P0746 caused by failed pressure sensors.
- Valve body. If the solenoid passes, check the valve body: Toyota looks for debris in the valves after the solenoid, and Honda, if the solenoid passes and the code returns, checks the shift valve.
- Replace pressure control solenoid A. Which one it is depends on the make: on Nissan, the line pressure solenoid; on Toyota, SL1; on Honda 5-speeds, linear solenoid A. Afterwards, do the relearn the carmaker requires.
It's a performance code, not an electrical one: before replacing the solenoid, measure line pressure with a gauge and fix any other codes first. On Nissan CVTs the solenoid isn't sold separately, so the diagnosis ends at the valve body or the CVT depending on the belt's condition.
Only as far as the shop: with high pressure engagements hit hard, and with low pressure the clutches or the CVT belt slip and get damaged.
What carmaker bulletins say34 carmaker bulletins and the vehicles they nameShow
34 service bulletins published by the US NHTSA mention this code, mostly from Nissan, Mazda, Chevrolet, GMC, Hyundai (1999–2022 models).
Vehicles with service bulletins for this code
- Nissan Versa 2013–2022
- Nissan Sentra 2013–2018
- Mazda Mazda3 2012–2013
- Buick Encore 2020–2021
- Hyundai Sonata 1999–2010
- Hyundai Santa Fe 2001–2010
- Chevrolet Equinox 2018–2020
- Buick Enclave 2018–2021
Engineering asks technicians to complete a checklist and contact the engineer about vehicles that will not move in Drive, Neutral and/or Reverse with DTCs P0746 and P0747.
Open the bulletin (PDF), page 1 ↗CVT with reduced launch on a quick exit from a stop/start event, sometimes with P0746 and P0776, because the main pump is slow to prime. The TCM is reprogrammed with updated software.
Open the bulletin (PDF), page 1 ↗Preliminary information: on the VT-40 CVT, replace both pressure sensors if DTCs P0746 or P0776 are set in the TCM.
Open the bulletin (PDF), page 1 ↗These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.
TSS parts for this code
Pick your transmission to see the TSS parts that fit it, or open all parts of this type:
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.