Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Fluid pressure sensor or switch

Code P0846: Transmission fluid pressure sensor/switch B range/performance

A fault in a transmission fluid pressure sensor or switch (A, B or C) or its circuit. On many transmissions these switches sit in the valve body or the solenoid pack.

What's failing

Fluid pressure sensor or switch

Most common cause

On Chrysler, the power feed

Can I drive with this code?

If the transmission is in limp mode or judders, drive slowly and only to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • On Chryslers (41TE, 42RLE, 62TE, RFE)Limp mode, the transmission stays in one gear with the check engine light on.
  • On Nissan CVTs (2013–2019 Sentra, Versa and Note)Judder when pulling away slowly, hesitation, lack of power or rpm flare.
  • On the Kia and Hyundai IVTThere may be no symptoms, just the light.
  • On Chrysler it can set together with P0882 or P0888 without the transmission being damaged

Most common causes

  1. 1On Chrysler, the power feedLow transmission relay voltage also sets P0846; fix P0882 or P0888 first.
  2. 2On Chrysler, connectors with moisture or corrosionChrysler issued a bulletin for the 2003–2005 Liberty, Wrangler, Dakota and Durango with the 42RLE (US) for these codes.
  3. 3On Chrysler, the 2-4 pressure switch inside the solenoid packOn the 62TE, if it sets with P0870, Chrysler replaces the solenoid/range sensor assembly.
  4. 4On the Nissan JF015E, software first and then the valve body or beltNissan reprograms the module, removes the valve body and inspects the belt.
  5. 5On the Kia and Hyundai IVT, the oil pressure sensor, if there's no driveability concern

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Are P0882 or P0888 set too?

On Chrysler, low transmission relay voltage also sets P0846 without the transmission being damaged.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Are P0882 or P0888 set too?Yes: «Power feed first» · No: step 2
  2. Step 2. Is your car a Chrysler, Dodge, Jeep or Ram with a 41TE, 42RLE, 62TE or RFE transmission?Yes: step 3 · No: step 5
  3. Step 3. Is the solenoid pack connector dry and clean, with no moisture or corrosion?Yes: step 4 · No: «Repair the connector»
  4. Step 4. Is P0870 set too?Yes: «Solenoid and range sensor assembly» · No: «Pressure and valve body»
  5. Step 5. Is your car a Kia or Hyundai with an IVT?Yes: step 6 · No: step 7
  6. Step 6. Does it drive normally, with no slipping, and without codes P0730, P0731 or P0741?Yes: «Replace only the sensor» · No: «The problem is the IVT»
  7. Step 7. Is there a transmission module reflash for your model?Yes: «Reflash the module» · No: «Valve body or belt»

Results

  • Power feed first. Fix P0882 or P0888 first: the transmission relay, the fuse and the splices, where you look for corrosion or water. Per Chrysler, once the power feed is repaired P0846 goes away and doesn't mean an internal fault.
  • Repair the connector. Dry, clean or repair the connector and its terminals before replacing the solenoid pack, then clear the code and test again.
  • Solenoid and range sensor assembly. On the 62TE, with P0846 and P0870 together, Chrysler replaces the solenoid/range sensor assembly and then runs the quick learn with the scan tool.
  • Pressure and valve body. Check the fluid level and measure line pressure with a gauge. If the pressure switch codes come back, check the valve body: the rebuilding industry ties solenoid switch valve wear to P0846. The switch is only replaced with the complete solenoid pack.
  • Replace only the sensor. With no driveability concern, Hyundai and Kia replace only the oil pressure sensor and the pan gasket, not the whole transmission.
  • The problem is the IVT. If it slips or sets with P0730, P0731 or P0741, it's no longer just the sensor: ask the dealer with your VIN about pending software updates and an IVT inspection.
  • Reflash the module. Ask the dealer to reflash the transmission module, then clear the code and road-test. If it returns, Nissan removes the valve body and inspects the belt.
  • Valve body or belt. On the JF015E, sensor B sits inside the valve body: Nissan removes it and inspects the belt before deciding what to replace. On other transmissions, confirm on your scan tool which part it is before buying it.
Diagnostic tip

The meaning changes by make: on Chrysler it's the 2-4 pressure switch rationality (2C on RFE units), an on/off switch inside the solenoid pack, not a 5 V sensor; on Nissan and the IVT it's pressure sensor B. Confirm the make and transmission before buying parts.

Can I drive with this code?

If the transmission is in limp mode or judders, drive slowly and only to the shop; if only the light is on in an IVT and it drives normally, it can be driven there carefully.

What carmaker bulletins say6 carmaker bulletins and the vehicles they nameShow

6 service bulletins published by the US NHTSA mention this code, mostly from Nissan, Jeep, Dodge, Kia (2003–2024 models).

Vehicles with service bulletins for this code

  • Nissan Versa 2013–2017
  • Nissan Versa Note 2014–2017
  • Kia Rio 2018–2023
  • Kia Forte 2019–2024
  • Jeep Wrangler 2003–2005
  • Dodge Dakota 2004–2005
  • Jeep Grand Cherokee 2003–2005
  • Dodge Durango 2004–2005
Bulletin TSB_TRA109 · 2024
Kia Rio 2018–2023 · Kia Forte 2019–2024 · Kia Seltos 2021–2024 · Kia Soul 2020–2024

IVT oil pressure sensor replacement: MIL on with DTCs P084500, P084600 and/or P0867XX and no driveability concerns, due to a failed sensor.

Open the bulletin (PDF) ↗
Bulletin NTB17-034k · 2020
Nissan Versa Note 2014–2017 · Nissan Versa 2013–2017

CVT judder and/or DTCs P0746, P0965, P17F0 or P0846 stored (amended bulletin; see the amendment history).

Open the bulletin (PDF), page 8 ↗
Bulletin NTB17-034j · 2019
Nissan Versa Note 2014–2017 · Nissan Versa 2013–2017

CVT judder and/or DTCs P0746, P0965, P17F0 or P0846 stored (amended bulletin; see the amendment history).

Open the bulletin (PDF), page 8 ↗
Bulletin NTB17-034i · 2019
Nissan Versa 2013–2017 · Nissan Versa Note 2014–2017 · Nissan Sentra 2013–2017

CVT judder and/or DTCs P0746, P0965, P17F0 or P0846 stored (amended bulletin; see the amendment history).

Open the bulletin (PDF), page 7 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for this code

Pick your transmission to see the TSS parts that fit it, or open all parts of this type:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.