Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Fluid pressure sensor or switch

Code P0848: Transmission fluid pressure sensor/switch B circuit high

A fault in a transmission fluid pressure sensor or switch (A, B or C) or its circuit. On many transmissions these switches sit in the valve body or the solenoid pack.

What's failing

Fluid pressure sensor or switch

Most common cause

The fluid

Can I drive with this code?

If it moves normally, it can be driven to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Check engine or transmission light on
  • On Silverado and Sierra HD trucks with the Allison (US), GM listed it with delayed or no engagement into D or R, especially when cold
  • On the 2012–2013 Mazda3 (US), it can set together with P0780 or P1738

Most common causes

  1. 1The fluidOn the Allison, GM says it can set after a fluid or filter service, from low fluid or after long storage, and checks the internal suction filter for cracks.
  2. 2Pressure switch/sensor B or its connector
  3. 3The sensor circuit open or shorted to voltage (high signal)
  4. 4On the 2003–2004 Acura MDX, Honda corrected its service manual for this code's diagnosisUse the updated procedure.

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Is the fluid at the right level and in good condition?

Check it first, especially if the code appeared after a service: on the Allison (US), GM says it can set after a fluid or filter service, with low fluid or after long storage.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Is the fluid at the right level and in good condition?Yes: step 2 · No: «Correct the fluid»
  2. Step 2. Is your car a Honda?Yes: step 3 · No: step 4
  3. Step 3. With the switch unplugged, is there about 5 V at its connector?Yes: «Replace the switch» · No: «Check the wire»
  4. Step 4. Is your car a Nissan with a CVT?Yes: step 5 · No: step 6
  5. Step 5. Is the 5 V supply reaching the sensor, and is the wiring to the computer OK?Yes: «Valve body, not the CVT» · No: «Open or shorted circuit»
  6. Step 6. Are the sensor or switch connector and circuit OK, with no opens or shorts to power?Yes: «Replace the sensor or switch» · No: «Open or shorted circuit»

Results

  • Correct the fluid. Correct the level with the fluid the carmaker specifies and check the internal suction filter for cracks, as GM does on the Allison. GM warns that replacing the module likely won't fix this code.
  • Replace the switch. If there's about 5 V at the connector, Honda replaces the switch, which is bolted to the outside of the transmission.
  • Check the wire. If there's no voltage, check the wire between the switch and the computer and repair it. If everything checks out, Honda updates the computer's software or tries a known-good one.
  • Valve body, not the CVT. With the supply and wiring OK, Nissan replaces the valve body, where the sensor sits. On the X-Trail, the manual ends in replacing the transmission, but the US bulletins for the Rogue and Altima say "do not replace the CVT": they replace the valve body, flush the cooler and load the calibration data.
  • Open or shorted circuit. Repair the open wire or the short to power, the connector or the 5 V supply before replacing parts, then clear the code and test again.
  • Replace the sensor or switch. With the connector and circuit OK, replace pressure sensor/switch B; first confirm on your scan tool which part it is on your transmission.
Diagnostic tip

Check fluid level and condition first, especially if the code appeared after a service: on the Allison, GM warns that replacing the module will likely not fix it.

Can I drive with this code?

If it moves normally, it can be driven to the shop; if it's slow to engage or won't move, don't force it.

What carmaker bulletins say11 carmaker bulletins and the vehicles they nameShow

11 service bulletins published by the US NHTSA mention this code, mostly from Mazda, GMC, Chevrolet, Acura (2001–2019 models). The repair they mention most: checking or replacing the valve body.

Vehicles with service bulletins for this code

  • Mazda Mazda3 2012–2013
  • GMC Topkick 2003–2010
  • GMC Sierra 2500 2001–2018
  • Chevrolet Silverado 2500 2001–2019
  • Chevrolet C Series 2003–2009
  • Acura MDX 2003–2004
Bulletin 012012003 · 2003
Acura MDX 2003–2004

Service manual fix for automatic transmission DTC P0848 or P0873.

Bulletin 05-003-14-2898A · 2014
Mazda Mazda3 2012–2013

MIL on with P0780 and/or P1738, with or without U0401 and other solenoid and pressure DTCs. A new programmed valve body was released to correct it.

Open the bulletin (PDF), page 1 ↗
Bulletin 05-003-14-2898 · 2014
Mazda Mazda3 2012–2013

MIL on with P0780 and/or P1738, with or without U0401 and other solenoid and pressure DTCs. A new programmed valve body was released to correct it.

Open the bulletin (PDF), page 1 ↗
Bulletin 05-005-13-2735C · 2013
Mazda Mazda3 2012–2013

MIL on with P0780 and/or P1738, with or without U0401 and other solenoid and pressure DTCs. A new programmed valve body was released to correct it.

Open the bulletin (PDF), page 1 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for this code

Pick your transmission to see the TSS parts that fit it, or open all parts of this type:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.