Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Fluid pressure sensor or switch

Code P0843: Transmission fluid pressure sensor/switch A circuit high

A fault in a transmission fluid pressure sensor or switch (A, B or C) or its circuit. On many transmissions these switches sit in the valve body or the solenoid pack.

What's failing

Fluid pressure sensor or switch

Most common cause

The fluid

Can I drive with this code?

If shifts are only firm, it can be driven to the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Check engine light on
  • Harsh shift, typically into 3rd or 5thGM documented this on 6T70 and 6T75 units (Acadia, Enclave, Traverse, Equinox, Terrain, SRX, LaCrosse) built in April and May 2010 (US).
  • On the 2006 4T65-E, GM switches to an alternate shift pattern and maximum line pressure
  • On Silverado and Sierra HD trucks with the Allison (US), GM listed it with delayed or no engagement into D or R, worse when cold

Most common causes

  1. 1The fluidOn the Allison, GM says these codes can set after a fluid or filter service, low fluid from leaks or long storage, and asks to check the internal suction filter for cracks.
  2. 2A misinstalled or contaminated filterOn 2011–2014 Allisons (US), GM found shrink-wrap from replacement filters plugging valve body separator plate orifices.
  3. 3The pressure switch or sensor, or a false readingGM has a TFP switch check to rule out false codes on its 6-speeds.
  4. 4The switch wiring or connector, open or shorted to voltage (high signal)
  5. 5On the 2006 4T65-E, the TCC release switch circuit, which GM flags with this code

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Is the fluid at the right level and in good condition?

On the Allison in HD pickups (US), GM says these codes can set with low fluid from leaks or after long storage.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Is the fluid at the right level and in good condition?Yes: step 2 · No: «Correct the fluid»
  2. Step 2. Was the fluid or filter changed shortly before the code appeared?Yes: «Check the filter» · No: step 3
  3. Step 3. Is your car a Honda?Yes: step 4 · No: step 5
  4. Step 4. With the switch unplugged, is there about 5 V at its connector?Yes: «Replace the switch» · No: «Check the wire»
  5. Step 5. Is your car a GM 6-speed, such as the 6T40, 6T70 or 6L80?Yes: «GM's check and the module» · No: step 6
  6. Step 6. Are the sensor or switch connector and circuit OK, with no opens or shorts to power, and is the 5 V supply there?Yes: «Replace the sensor or switch» · No: «Open or shorted circuit»

Results

  • Correct the fluid. Correct the level with the fluid the carmaker specifies and fix the leak. On the Allison, GM warns that replacing the module likely won't correct this code or low line pressure.
  • Check the filter. Check the level and that the filter is correctly installed, with no cracks: on 2011–2014 Allisons (US), GM found packaging plastic from replacement filters plugging the valve body plate orifices.
  • Replace the switch. If there's about 5 V at the connector, Honda replaces the switch. It's bolted to the outside of the transmission.
  • Check the wire. If there's no voltage, check the wire between the switch and the computer and repair it. If everything checks out, Honda updates the computer's software or tries a known-good one.
  • GM's check and the module. GM has a switch check to rule out false codes on its 6-speeds. On the 6L80 it runs a cleaning routine with the scan tool and checks that each switch changes when 2nd and 5th are commanded; if one doesn't, it replaces the module, which holds the switch, and does the relearn.
  • Replace the sensor or switch. With the circuit and supply OK, replace the pressure sensor or switch: on the Compass, Patriot and Caliber with the CVT, Chrysler replaces the sensor in the valve body. Note that on the 2006 4T65-E, GM uses this code for the TCC release switch.
  • Open or shorted circuit. Repair the open wire or the short to power, or the connector, before replacing the sensor, then clear the code and test again.
Diagnostic tip

On the Allison in HD pickups (US), GM warns that replacing the module will likely not correct this code or low line pressure: check level, the internal suction filter and that no filter packaging was left behind first.

Can I drive with this code?

If shifts are only firm, it can be driven to the shop; if it's slow to engage D or R or won't move, don't force it: it may be lacking pressure.

What carmaker bulletins say14 carmaker bulletins and the vehicles they nameShow

14 service bulletins published by the US NHTSA mention this code, mostly from Chevrolet, GMC, Mazda, Cadillac, Buick (2001–2019 models).

Vehicles with service bulletins for this code

  • Chevrolet Silverado 2500 2001–2019
  • Mazda Mazda3 2012–2013
  • GMC Sierra 2500 2001–2018
  • Chevrolet Silverado 3500 2001–2013
  • GMC Topkick 2003–2010
  • Cadillac SRX 2007–2010
  • Buick Enclave 2008–2010
  • Buick Lacrosse 2010
Bulletin PI-0179 · 2010
Chevrolet Equinox 2010 · Cadillac SRX 2010 · GMC Acadia 2010 · Buick Lacrosse 2010

6T70/6T75 built 4/1/10–5/8/10: harsh shift, typically into 3rd or 5th, with DTC P0843 in the TCM as history or active.

Bulletin 070730015 · 2007
Chevrolet Silverado 3500 2007 · Pontiac G6 2007 · Chevrolet Corvette 2006–2007 · Chevrolet Silverado 2500 2007

6T70, 6T75, 6L50, 6L80 and 6L90: how to check the TFP switch for false DTCs P0842, P0843, P0872, P0873, P0877, P0878, P0989 or P0990.

Bulletin 030730011 · 2007
GMC Sierra 2500 2001–2003 · Chevrolet Silverado 2500 2002–2003 · GMC Sierra 3500 2001–2003 · Chevrolet Silverado 3500 2001–2003

Allison transmission with delayed engagement, cold hesitation and MIL on, with DTCs P0701, P1709, P1711, P1713, P0841, P0843, P0847, P0870, P0872 and P0875.

Open the bulletin (PDF) ↗
Bulletin 030730011B · 2005
Chevrolet Silverado 2001–2003 · GMC Sierra 2001–2003

Transmission slips, delayed engagement, cold hesitation, intermittent performance or shift issues, with DTCs P0701, P1709, P1711, P1713, P0841, P0843, P0847, P0870, P0872 or P0875.

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 6T70 · 6L80

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.