Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Shift solenoid

Code P0751: Shift solenoid A performance or stuck off

A fault in a shift solenoid (A, B, C, D or E) or its circuit, or the solenoid doesn't do what the computer commands. The transmission usually stays in one gear.

What's failing

Shift solenoid

Most common cause

Low, damaged or contaminated fluid

Can I drive with this code?

Only as far as the shop

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Some shifts missing or stuck in one gearOn Ford's 6R80, it uses only 5th and 6th, with harsh reverse engagement.
  • Starts off in a high gearOn the 6L80 (Silverado, Tahoe), GM documented 4th-gear starts, poor acceleration and slipping from a launch (US).
  • On the 4L60E, the computer sees the wrong ratio when it commands 1st or 4th
  • Check engine light on

Most common causes

  1. 1Low, damaged or contaminated fluidOn heavy-duty Allisons (US), GM found packaging plastic from some spin-on filters plugging separator plate orifices.
  2. 2A sticking valve in the valve bodyOn the 6L80, GM found a solenoid valve sticking in its bore and replaces the lower valve body (US).
  3. 3A damaged clutchFord tied it to direct clutch failure on the 2008–2011 Focus (US), and on the 5R110W in 2009–2016 trucks, to a fatigued coast clutch cylinder weld.
  4. 4Shift solenoid A, which varies by makeOn the 4L60E it's the 1-2 solenoid; on Ford, SSA; on Honda, solenoid A, which can click and the fault still be in the shift valve.
  5. 5SoftwareToyota fixed it with an update on the 2008–2011 Land Cruiser (US).

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Is there also an electrical code for solenoid A, such as P0750, P0753, P0973 or P0974?

P0751 is a performance code: Ford flags it as a non-electrical fault, where the circuit is fine but the transmission didn't make the shift.

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Is there also an electrical code for solenoid A, such as P0750, P0753, P0973 or P0974?Yes: «Fix the circuit first» · No: step 2
  2. Step 2. Is the fluid at the right level and in good condition, with no burnt smell or water?Yes: step 3 · No: «Correct the fluid»
  3. Step 3. Are the filter and pan clean, with no debris, plastic or clutch material?Yes: step 4 · No: «Debris in the fluid»
  4. Step 4. Is there a software update for your VIN?Yes: «Update the software» · No: step 5
  5. Step 5. Does solenoid A pass the scan tool activation test and the leak test?Yes: step 6 · No: «Replace solenoid A»
  6. Step 6. Is the valve body clean, with no debris or sticking valves?Yes: «Check the clutches» · No: «Valve body»

Results

  • Fix the circuit first. The electrical code for the same solenoid comes first: look it up in this tool and follow its diagnosis. Then clear the codes and road-test.
  • Correct the fluid. Set the right level with the fluid the carmaker specifies and check the filter, then clear the code and road-test. If the fluid smells burnt or has water in it, the transmission needs an inside inspection before replacing the solenoid.
  • Debris in the fluid. Debris plugs orifices and jams valves in the valve body. Replace the filter and check the valve body before replacing the solenoid; if it's clutch material, check the clutches too.
  • Update the software. Ask the dealer for the reflash for your VIN, then clear the code and road-test.
  • Replace solenoid A. If it fails the activation or leak test, replace solenoid A and do the relearn the carmaker requires.
  • Valve body. A sticking valve or a plugged orifice blocks the shift even when the solenoid works. Repair or replace the valve body and do the relearn: on the 6L80, GM replaces the lower valve body (US).
  • Check the clutches. With the fluid, solenoid and valve body OK, check the clutches: Ford tied P0751 to direct clutch failure on the 2008–2011 Focus (US) and repairs it with a direct clutch kit and a seal kit. On the 5R110W in 2009–2016 trucks, Ford air-tests the coast clutch before removing the transmission.
Diagnostic tip

Ford flags it as a non-electrical fault: the circuit is fine, but the transmission didn't make the shift. Before replacing the solenoid, check fluid and filter and look for debris in the pan; if the solenoid clicks and the code returns, Honda says to check shift valve A. On GM and Honda, this solenoid's circuit codes are P0973 and P0974.

Can I drive with this code?

Only as far as the shop: the transmission may start off in a high gear or stick in one, and if a clutch slips, it gets worse.

What carmaker bulletins say46 carmaker bulletins and the vehicles they nameShow

46 service bulletins published by the US NHTSA mention this code, mostly from Ford, GMC, Chevrolet, Lincoln, Mazda (1997–2023 models).

Vehicles with service bulletins for this code

  • Ford F-150 2017–2023
  • Chevrolet Silverado 2500 2001–2019
  • GMC Sierra 2500 2001–2019
  • GMC Sierra Denali 2003–2019
  • Ford Mustang 2018–2023
  • Lincoln Navigator 2018–2023
  • Chevrolet Silverado 2001–2017
  • Mazda Mazda3 2012–2013
Bulletin PI1344C · 2019
GMC Yukon Xl 2010–2019 · GMC Sierra Denali 2010–2019 · GMC Yukon 2010–2019 · Chevrolet Suburban 2010–2019

Preliminary information adding the 2016 model year to diagnostic tips and repair info for reduced low-speed acceleration and/or slipping from a launch, with DTC P0751.

Open the bulletin (PDF), page 1 ↗
Bulletin PI1344B · 2015
GMC Savana 2010–2016 · Cadillac CTS 2010–2015 · Cadillac Escalade Esv 2010–2015 · Chevrolet Silverado 2010–2016

Reduced low-speed acceleration or slipping from a launch, with P0751. May be the clutch select solenoid valve 2 (359) in the lower valve body sticking, causing a 4th gear start. Very intermittent.

Open the bulletin (PDF), page 1 ↗

These are US bulletins: check with your dealer or shop whether they apply to your car. Bulletins open on NHTSA's site, at the page where the repair starts.

TSS parts for the transmissions in these bulletins

Buy in

Different transmission? Pick it and we'll show its parts:

See parts →

Find the part by its number on the exploded diagram: 6T70 · 6L80 · 4T40E

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.