If DTCs P0758, P0763 or P1758 remain or shifting is erratic after installing a remanufactured transmission, check ground G151 per the wiring manual.
Code P0758: Shift solenoid B electrical
A fault in a shift solenoid (A, B, C, D or E) or its circuit, or the solenoid doesn't do what the computer commands. The transmission usually stays in one gear.
Shift solenoid
The solenoid connector or wiring
Only as far as the shop
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- Stuck in one gearA 4L60E with a solenoid B circuit fault stays in 3rd with maximum pressure; Hyundai and Kia 6-speeds hold 4th (US).
- Erratic shiftsGM documented it on the 2003 Alero and Grand Am together with an erratic speedometer and inoperative cruise control (US).
- Check engine light on
Most common causes
- 1The solenoid connector or wiringOpen, shorted, wet or corroded.
- 2A ground or the power feedOn the 2001–2003 Acura CL, TL and MDX (US), if P0758 remained after installing a remanufactured transmission, Honda said to check a harness ground.
- 3The internal harnessOn the VW 01M, several solenoid codes at once usually point to the harness or the shared feed.
- 4Shift solenoid B, which varies by unitOn the 4L60E it's the 2-3 solenoid; on the 01M, N89; on Hyundai and Kia 6-speeds, the 26 solenoid, which Kia says to replace without replacing the transaxle.
- 5The computer, lastKia replaces it only after the solenoid and the harness.
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Are other solenoid codes set along with P0758, such as P0753?
On the VW 01M, several solenoid codes at once usually point to the harness or the shared power feed.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Are other solenoid codes set along with P0758, such as P0753?Yes: «Check what they share» · No: step 2
- Step 2. Are the transmission connector and pins clean and tight, with no water or corrosion?Yes: step 3 · No: «Repair the connector»
- Step 3. Measured at the transmission connector, is solenoid B's coil within your transmission manual's value?Yes: step 4 · No: «Internal harness or solenoid B»
- Step 4. Are the wires between the computer and the transmission OK, with no opens or shorts, and is power getting through?Yes: step 5 · No: «Wires or power feed»
- Step 5. Are the transmission harness grounds OK?Yes: step 6 · No: «Repair the ground»
- Step 6. With the scan tool connected, does the code or the reading change when you move the harness?Yes: «Bad contact» · No: «The computer, last»
Results
- Check what they share. When several solenoid codes set, first check what they share: the harness, connector, ground and power feed. One of those failing is more likely than two solenoids at once.
- Repair the connector. Clean or repair the connector and pins, clear the code and test again.
- Internal harness or solenoid B. If it measures wrong at the transmission connector, the fault is inside: the internal harness or solenoid B. On Hyundai and Kia 6-speeds it's the 26 solenoid, which Kia says to replace without replacing the transaxle. Then clear the code and drive two cycles through every gear.
- Wires or power feed. Repair the open or shorted wire between the computer and the transmission, or the power feed, before touching the solenoid.
- Repair the ground. Clean and tighten or repair the harness ground, clear the code and test again before suspecting the computer.
- Bad contact. If it changes when you move the harness, that's where the fault is: find the damaged connector or section and repair it.
- The computer, last. Kia replaces the computer only after the solenoid and the harness. With everything above OK, check it, then clear the code and drive two cycles through every gear to confirm.
Follow Kia's order: activation test with the scan tool (if you can hear it, the harness isn't open or shorted at that moment), check the pins and connector, replace the solenoid, clear the code and drive two cycles; if it returns, the harness between the computer and the transmission, and the computer last.
Only as far as the shop: the transmission stays in its limp mode, and driving it that way heats and wears the clutches.
What carmaker bulletins say20 carmaker bulletins and the vehicles they nameShow
20 service bulletins published by the US NHTSA mention this code, mostly from Pontiac, Toyota, Honda, Chevrolet, Oldsmobile (1996–2017 models).
Vehicles with service bulletins for this code
- Honda Accord 1998–2002
- Chevrolet Cavalier 2000–2004
- Toyota RAV4 2001–2003
- Honda Odyssey 1999–2002
- Acura Cl 2001–2003
- Acura TL 1996–2003
- Buick Regal 2000–2004
- Buick Park Avenue 2000–2004
Erratic speedometer, erratic shifting and inoperative cruise control, with DTCs P0502, P0758 and P1860.
Troubleshooting information for automatic transmission DTCs P0753, P0758, P1705 and P1768.
These are US bulletins: check with your dealer or shop whether they apply to your car.
TSS parts for the transmissions in these bulletins
Different transmission? Pick it and we'll show its parts:
Find the part by its number on the exploded diagram: CD4E
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.
