4T45-E transmission: no reverse, binds in reverse or no movement, with DTC P0756. Perform the repair outlined in the bulletin.
Code P0756: Shift solenoid B performance or stuck off
A fault in a shift solenoid (A, B, C, D or E) or its circuit, or the solenoid doesn't do what the computer commands. The transmission usually stays in one gear.
Shift solenoid
Debris in the valve body
Only as far as the shop
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- Stuck in one gear or a shift missingOn the 6R80, it defaults to 3rd or 5th, or hangs in 2nd on acceleration.
- No reverse, 3rd or 5thFord documented it on the 2015–2016 Edge and Explorer (US).
- Starts off in a higher gearGM documented it on the 2005 Colorado and Canyon (US).
- Check engine light on
Most common causes
- 1Debris in the valve bodyOn the 4L60E, GM says the most likely cause is debris plugging a valve body orifice or a stuck 2-3 shift valve, and that replacing only the solenoid won't fix it unless it's cracked, broken or leaking (US).
- 2Low, damaged or water-contaminated fluidGM tied water in the fluid to P0756 on the 6L80.
- 3A damaged clutchFord tied it to direct clutch damage on the 2015–2016 Edge and Explorer (US).
- 4Shift solenoid B, which varies by makeOn the 4L60E it's the 2-3 solenoid; on Ford, SSB (on the 6R80 it feeds the 3-5-reverse clutch, and on the 5R110W, the overdrive clutch).
- 5SoftwareGM fixed a P0756 on the 2007 6L80 by reprogramming the module (US).
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Is there also an electrical code for solenoid B, such as P0755, P0758, P0976 or P0977?
P0756 is a performance code: on GM and Honda, a fault in this solenoid's circuit sets P0976 or P0977, not P0756.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Is there also an electrical code for solenoid B, such as P0755, P0758, P0976 or P0977?Yes: «Fix the circuit first» · No: step 2
- Step 2. Is the fluid at the right level and in good condition, with no water or burnt smell?Yes: step 3 · No: «Correct the fluid»
- Step 3. Has the transmission lost reverse, 3rd and 5th?Yes: «Check the clutches» · No: step 4
- Step 4. Is there a software update for your VIN?Yes: «Update the software» · No: step 5
- Step 5. Does solenoid B pass the leak test?Yes: step 6 · No: «Replace solenoid B»
- Step 6. Is the valve body clean, with no plugged orifices and no stuck 2-3 valve?Yes: «Check the clutches» · No: «Plugged orifice or stuck valve»
Results
- Fix the circuit first. The electrical code for the same solenoid comes first: look it up in this tool and follow its diagnosis. Then clear the codes and road-test.
- Correct the fluid. Set the right level with the fluid the carmaker specifies and check the filter. If the fluid has water in it or smells burnt, the transmission needs an inside inspection before replacing the solenoid.
- Check the clutches. Check the clutch that applies the missing gears. On the 2015–2016 Edge and Explorer (US), Ford found the direct clutch (the 3-5-reverse clutch) damaged, replaces the input speed sensor along with the clutch parts and cleans the metal particles out of the transmission.
- Update the software. Ask the dealer for the reflash for your VIN, then clear the code and road-test.
- Replace solenoid B. If it leaks or is broken, replace solenoid B (the 2-3 solenoid on the 4L60E; SSB on Ford) and do the relearn the carmaker requires.
- Plugged orifice or stuck valve. Repair or replace the valve body: debris plugging an orifice or a stuck 2-3 valve isn't fixed by replacing the solenoid. Replace the filter too, and do the relearn the carmaker requires.
On the 4L60E don't start with the solenoid: GM says to remove the spacer plate, inspect orifice #29 and the 2-3 shift valve, and test the solenoid only with a leak test. On GM and Honda, this solenoid's circuit faults set P0976 or P0977, not P0756.
Only as far as the shop: the transmission can stick in one gear or start off in a high one, and if a clutch slips, it gets worse.
What carmaker bulletins say64 carmaker bulletins and the vehicles they nameShow
64 service bulletins published by the US NHTSA mention this code, mostly from Chevrolet, GMC, Ford, Lincoln, Mazda (1995–2023 models).
Vehicles with service bulletins for this code
- Ford F-150 2017–2023
- Ford Mustang 2018–2023
- Lincoln Navigator 2018–2023
- GMC Sierra 2500 2001–2018
- Chevrolet Silverado 2500 2001–2019
- GMC Sierra 2001–2017
- Chevrolet Silverado 3500 2001–2017
- Mazda Mazda3 2012–2013
6L80: 4-5 upshift slip or flare causing a harsh shift or clunk, MIL on and DTC P0756. Fix: reprogram the TCM.
Diagnostic tips for automatic transmission DTC P0756.
These are US bulletins: check with your dealer or shop whether they apply to your car.
TSS parts for the transmissions in these bulletins
Cuerpo de Válvulas Reconstruido 6L80 2010-UP Casting 0955
Solenoide EPC 4L60E 4L30E 4L80E 4T80E
Harness Interno Macho 11 Pin 1991/03 4L80E
Solenoide Cambios A-B Transmision Caja Automatica 4L60E OEM 24230298
Placa Cuerpo de Valvulas 1996/06 4L60E 4L65E
Ramal De Cables Interno Con Solenoide Lock Up (TCC) (Con ISS En El Estator) 4L60E, 4L65E 2006/08
KIT SOLENOIDE DE CAMBIOS A-B 4L60E
Different transmission? Pick it and we'll show its parts:
Find the part by its number on the exploded diagram: 6L80 · 4L80E · 6T70 · 4L60E
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.