Service engine/vehicle soon lamp on, transmission slips, no upshift or erratic shifts, with DTCs P0753 and P1860.
Code P0753: Shift solenoid A electrical
A fault in a shift solenoid (A, B, C, D or E) or its circuit, or the solenoid doesn't do what the computer commands. The transmission usually stays in one gear.
Shift solenoid
The solenoid connector or wiring
Only to the shop
What car do you have?
Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.
Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →
Symptoms
- A shift is missing or it stays in one gearOn Chrysler's 46RE and A518, no shift into 4th (overdrive).
- Limp modeHyundai documented 6-speeds held in 4th with this and other solenoid codes (US).
- Slipping, no upshift or erratic shiftsGM documented this with P0753 and P1860 on the 4T65-E in the 2003 LeSabre and Park Avenue.
- Check engine light on
Most common causes
- 1The solenoid connector or wiringOpen, shorted, wet or corroded.
- 2The power feedA fuse or a wire shorted to ground; on the 1998–2002 Accord (US), Honda found a wire shorted behind the alternator that blew fuse 6 and left P0753.
- 3On the 46RE, the transmission relay, which shares the circuit with the overdrive solenoid
- 4The internal harnessOn the VW 01M, several solenoid codes at once usually mean the harness or the shared power feed.
- 5Shift solenoid A, which varies by unitOn the 4L60E it's the 1-2 solenoid; on the 46RE, the overdrive solenoid; on the 01M, N88; on Hyundai and Kia 6-speeds, the UD solenoid, which Hyundai replaces together with its harness.
- 6The computer, last
From most common and easiest to check to least common.
Follow these steps
Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.
Are other solenoid codes set along with P0753, such as P0758?
On the VW 01M, several solenoid codes at once usually mean the harness or the shared power feed, and on the 4L60E those solenoids share the 3-2 solenoid's fuse.
It's guidance: a technician with a scan tool makes the final diagnosis.
See every step and resultShow
- Step 1. Are other solenoid codes set along with P0753, such as P0758?Yes: «Check what they share» · No: step 2
- Step 2. Tested with a meter, is the transmission fuse good?Yes: step 3 · No: «Blown fuse»
- Step 3. Are the transmission connector and pins clean and tight, with no water or corrosion?Yes: step 4 · No: «Repair the connector»
- Step 4. Are the wires between the computer and the transmission OK, with no opens or shorts, and is power getting through?Yes: step 5 · No: «Wires or power feed»
- Step 5. Measured at the transmission connector, is solenoid A's coil within your transmission manual's value?Yes: step 6 · No: «Internal harness or solenoid A»
- Step 6. With the scan tool connected, does the code or the reading change when you move the harness?Yes: «Bad contact» · No: «The computer, last»
Results
- Check what they share. First check the fuse, power feed, connector and harness they share. On the 4L60E, GM checks the fuse and power feed, and tests each solenoid sharing that fuse for a short to ground.
- Blown fuse. Replace the fuse and find the short to ground that blew it before testing further: if you don't repair it, it will blow again.
- Repair the connector. Clean or repair the connector and pins, clear the code and test again.
- Wires or power feed. Repair the open or shorted wire, or the power feed (on the 46RE, also the transmission relay), before touching the solenoid.
- Internal harness or solenoid A. If it measures wrong at the transmission connector, the fault is inside: the internal harness or solenoid A. On Hyundai and Kia 6-speeds, Hyundai replaces the UD solenoid together with its harness. Afterwards, do the relearn the carmaker requires.
- Bad contact. If it changes when you move the harness, that's where the fault is: find the damaged connector or section and repair it.
- The computer, last. With the fuse, connector, wires and solenoid OK, check the computer's ground and, last, the computer.
Measure the solenoid coil from the transmission case connector against that unit's spec and test the fuse with a meter. On the 46RE, if only 4th is missing, first rule out the normal cases: overdrive switched off, very cold or very hot fluid, or tow/haul mode.
Only to the shop: depending on the unit it may stay in one gear or slip, and driving it that way heats and wears the clutches.
What carmaker bulletins say18 carmaker bulletins and the vehicles they nameShow
18 service bulletins published by the US NHTSA mention this code, mostly from Honda, Pontiac, Chevrolet, Toyota, Buick (1996–2017 models).
Vehicles with service bulletins for this code
- Honda Accord 1998–2002
- Chevrolet Cavalier 2000–2004
- Buick Park Avenue 2000–2004
- Buick Lesabre 2000–2004
- Honda Odyssey 1999–2002
- Toyota RAV4 2001–2003
- Chevrolet Monte Carlo 2000–2004
- Toyota Cavalier 2000
Troubleshooting information for automatic transmission DTCs P0753, P0758, P1705 and P1768.
These are US bulletins: check with your dealer or shop whether they apply to your car.
TSS parts for this code
Pick your transmission to see the TSS parts that fit it, or open all parts of this type:
Buying wholesale or own a parts store?
We'll send you a quote or tell you how to sell TSS in your area.