Featured: TSS RTD Link by HP Tuners
Black Friday15% off TSS kits · Nov 27–3015% off TSS kits · ends Nov 30
TSS Genuine Parts — home
System: Shift solenoid

Code P0973: Shift solenoid A control circuit low

A fault in a shift solenoid (A, B, C, D or E) or its circuit, or the solenoid doesn't do what the computer commands. The transmission usually stays in one gear.

What's failing

Shift solenoid

Most common cause

A short to ground or an open circuit

Can I drive with this code?

It can be driven carefully to the shop, but if the transmission stays in one gear or slips, drive slowly and as little as possible

Diagnosis for your car

What car do you have?

Pick your car and we'll tell you which transmission it has, which TSS parts fit it for this code, and whether there are bulletins for your model.

Can't find your car, or not sure which transmission it has? We'll help you identify it. Ask us →

Symptoms

  • Check engine light on and odd shifting; the transmission may lose some gears
  • On GM's 2006 4T65-E, it switches to an alternate shift pattern
  • If it sets together with P0976 or P0977 (solenoid B), the likely cause is something they share, such as the connector, harness or power feed
  • On Honda (Accord, CR-V, Civic) and Acura, warning light on with the shift solenoid A short code

Most common causes

  1. 1A short to ground or an open circuitOn the 4L60E, GM sets it for a continuous open or ground short in the solenoid A circuit; on Honda it's a short.
  2. 2The transmission or solenoid connectorLoose, dirty or wet, or a chafed harness.
  3. 3A shorted shift solenoid A winding
  4. 4Power and groundsOn Hino trucks (US), these codes set from low voltage between the transmission case and the battery post.
  5. 5The computer, last

From most common and easiest to check to least common.

Step-by-step diagnosis

Follow these steps

Answer yes or no and we'll tell you what to check next, in the order of the carmakers' manuals.

Step 1

Is P0976 or P0977 (solenoid B) set too?

It's guidance: a technician with a scan tool makes the final diagnosis.

See every step and resultShow
  1. Step 1. Is P0976 or P0977 (solenoid B) set too?Yes: «Check what they share» · No: step 2
  2. Step 2. Are the transmission and solenoid connectors clean, dry and tight, and the harness free of chafing?Yes: step 3 · No: «Connector or harness»
  3. Step 3. With the scan tool connected, does the code or the reading change when you move the harness?Yes: «Bad contact» · No: step 4
  4. Step 4. Measured with a meter, is the solenoid A circuit OK, with no shorts to ground or opens?Yes: step 5 · No: «Short to ground or open circuit»
  5. Step 5. Are the power feed and grounds OK, with no low voltage between the transmission case and the battery post?Yes: step 6 · No: «Power feed or grounds»
  6. Step 6. Measured at the connector, is solenoid A's coil within your transmission manual's value?Yes: «The computer, last» · No: «Replace solenoid A»

Results

  • Check what they share. If it sets together with P0976 or P0977, the likely cause is something they share, such as the connector, harness or power feed, not two solenoids at once. Check those before replacing parts.
  • Connector or harness. Clean, dry or repair the connector and the chafed harness, then clear the code and test again.
  • Bad contact. If the code changes when you move the harness, that's where the fault is: find the damaged connector or section and repair it.
  • Short to ground or open circuit. Repair the wire shorted to ground or open between the computer and the solenoid before replacing parts, then clear the code and test again.
  • Power feed or grounds. Repair the power feed and grounds, including the connection between the transmission case and the battery post, then clear the code and test again.
  • Replace solenoid A. With the connector, harness and power feed OK and the winding out of spec, replace shift solenoid A and do the relearn the carmaker requires.
  • The computer, last. With the connector, harness, power feed and solenoid OK, check the computer, always last.
Diagnostic tip

It's an electrical code: Honda says these circuit codes cannot come from a mechanical fault. GM and Honda use it instead of P0750, and Toyota also does on the Corolla with the U341E. Wiggle-test the harness and check the connector and solenoid resistance before opening the transmission.

Can I drive with this code?

It can be driven carefully to the shop, but if the transmission stays in one gear or slips, drive slowly and as little as possible.

What carmaker bulletins say3 carmaker bulletins and the vehicles they nameShow

3 service bulletins published by the US NHTSA mention this code, mostly from Honda, Acura (2005–2005 models).

Vehicles with service bulletins for this code

  • Honda Accord 2005
  • Acura Rsx 2005
  • Honda Cr-V 2005
Bulletin 05071 · 2005
Honda Accord 2005 · Honda Cr-V 2005

MIL on with DTC P0973 (short in shift solenoid valve A circuit).

Bulletin 705 · 2005
Honda Accord 2005

DTC P0973: shift solenoid A short circuit.

These are US bulletins: check with your dealer or shop whether they apply to your car.

TSS parts for this code

Pick your transmission to see the TSS parts that fit it, or open all parts of this type:

See parts →

Related codes

← See all codes

Buying wholesale or own a parts store?

We'll send you a quote or tell you how to sell TSS in your area.