
- The 2007 to 2014 Dodge Attitude and the 2004 to 2006 Verna were only automatic with the 1.6 engine, using a Hyundai 4-speed; from 2015, the Attitude is a Mitsubishi with a CVT.
- Through 2011 it's the A4AF3, which Hyundai names in its Accent 1.6; from 2012 to 2014, an A4CF-family unit, most likely the A4CF1.
- In Mexico, the Dodge Atos and i10 were manual only.
- With a shift solenoid A or pressure solenoid A fault, Hyundai locks the A4AF3 in 3rd; ratio codes are mostly mechanical.
- It takes SP-III, not SP-IV: 6.1 liters in the A4AF3 and about 6.8 in the A4CF1.
The 2007 to 2014 Dodge Attitude and the 2004 to 2006 Verna were Hyundai's Accent sold by Dodge in Mexico, and only the 1.6 engine came with an automatic: a Hyundai 4-speed. Through 2011 it's the A4AF3; from 2012 to 2014, an A4CF-family unit. This guide pulls together what Hyundai and Kia's service manuals and bulletins say: which one your car has, its problems by symptom, the codes, test values, the fluid and TSS parts. The 2015-on Attitude is a Mitsubishi with a CVT, which we cover in the Mitsubishi guide.
Which automatic does your Attitude or Verna have?
| Vehicle in Mexico | Automatic transmission |
|---|---|
| Verna 2004 to 2006 | Only the 1.6 was automatic ("Automática de 4 velocidades"); the 1.5 was manual. By its codes and fluid, the A4AF3 |
| Attitude 2007 to 2011 | Automatic only with the 1.6 (2011: "Automática 4 velocidades"); the 1.4 was manual. The A4AF3 |
| Attitude 2012 to 2014 | 1.6 "Aut. de 4 vels. Modo Manual"; the 1.4 was a 5-speed manual (6-speed in 2014). A4CF family, most likely the A4CF1 |
| Attitude 2015 to 2023 | No: it's a Mitsubishi with a CVT (Mitsubishi guide) |
| Dodge Atos and i10 | No: the Dodge México spec sheets we checked (Atos from several years between 2003 and 2012, and i10 2012 to 2014) list them with a 5-speed manual only |
| Hyundai Grand i10 | "Automática / 4" on the GL MID and GLS versions in the 2018, 2019 and 2024 spec sheets; TSS sells its parts as A4CF0 |
Mexican spec sheets don't print the transmission code: we infer it from Hyundai and Kia's US manuals for the same engine. The 2012-on US 6-speed Accent wasn't sold as the Attitude. More models in the Dodge, Jeep, Ram and Chrysler and Hyundai and Kia guides.
How do you tell the A4AF3 from the A4CF1?
| What to check | A4AF3 and A4CF1 |
|---|---|
| A4AF3 | Hyundai's Accent 1.6 transmission, named that way on the transmission tag: the one in the Verna 1.6 and in the Attitude 1.6 through 2011 |
| A4CF1 | The unit Kia pairs with that era's 1.6 engine: the most likely one in the 2012 to 2014 Attitude 1.6 (Dodge México doesn't print the code) |
| Computer | On the A4AF3, the engine computer (PCM), which includes transmission control |
| Gearsets and clutches | A4AF3: one Ravigneaux planetary set, front, rear and end clutches, a kickdown band and a low and reverse brake. A4CF1: two planetary sets, underdrive, overdrive and reverse clutches, and two brakes |
| Solenoids | A4AF3: three shift solenoids (A, B and C), two pressure solenoids (A and B) and a converter clutch solenoid. A4CF1: five control solenoids and one that varies line pressure from 4.5 to 10.5 bar (VFS) |
| Ratios | A4AF3: 2.846, 1.581, 1.000 and 0.685. A4CF1: 2.919, 1.551, 1.000 and 0.713 |
| Codes that give it away | P0745, P0775 or P1709 means an A4AF3; P0748 or P0765, an A4CF |
| If the electronics fail | The A4AF3 stays in 3rd with a shift solenoid A or pressure solenoid A fault; the A4CF1 is designed to drive in 3rd and reverse |
| Dipstick | The A4AF3 has one: the level is checked hot, at the HOT mark |
Problems by symptom
This is what Hyundai's service manuals and its US bulletins say about these units:
| Symptom | What Hyundai says |
|---|---|
| Stuck in 3rd with the check engine light on | With a shift solenoid A or pressure solenoid A circuit fault (P0750, P0745), Hyundai leaves the A4AF3 "locked in 3rd gear". Check the transmission's 6-pin connector and measure the solenoids before blaming the computer |
| Slips in D | If the stall test goes above 2,800 rpm in D, Hyundai points to the rear clutch or the one-way clutch (A4AF3) |
| Slips in reverse | If it's high in R, the front clutch or the low and reverse brake (A4AF3) |
| No 2nd or 4th, or code P1709 | The kickdown band, its servo and its switch: per Hyundai's pressure chart, the band works in 2nd and 4th |
| Ratio codes (P0731 to P0734) | Hyundai says they're mostly mechanical, such as a sticking valve or a solenoid that doesn't work right, rather than electrical |
| Harsh or delayed R or D engagement | In the US, Hyundai issued bulletins for this on the 1996 to 2002 Accent; on 2001 and 2002 models, with a computer reprogram |
| Speed sensor codes (P0717, P0722) | The input and output sensors; in the US, Hyundai issued bulletins to check them and reprogram the computer on the 1996 to 2004 Accent |
| Range sensor codes (P0705, P0707, P0708) | A misadjusted or faulty range sensor, per a 2009 Hyundai bulletin (US) |
| Harsh shifts after a repair | The computer adapts pressure to clutch wear; Hyundai has a procedure to erase and relearn those values with a scan tool |
| The lever won't come out of P | In the US, the Accent had recalls for the brake light switch, which also controls the shift lock: check that the brake lights come on |
Trouble codes
| Code | What it means, according to Hyundai |
|---|---|
| P0750, P0755 and P0760 | A4AF3 shift solenoids A, B and C; with A, the transmission is locked in 3rd (guide) |
| P0745 and P0775 | A4AF3 pressure solenoids A and B: A controls the front and end clutches, the band and the low and reverse brake; B, the rear clutch. With A, it stays in 3rd (guide) |
| P0748 and P0765 | A4CF only: the line pressure solenoid (VFS) and the fourth control solenoid |
| P0741 and P0743 | Converter clutch: with P0741, it still slips more than 100 rpm with the solenoid at 100%; P0743 is the solenoid circuit |
| P0717 and P0722 | Input and output speed sensors, above 30 km/h (19 mph); the computer enters fail-safe (guide) |
| P0731, P0732, P0733 and P0734 | Incorrect ratio in 1st, 2nd, 3rd or 4th; mostly mechanical (guide) |
| P0712 and P0713 | Fluid temperature sensor, in the valve body; with P0712, the computer assumes 80 °C (176 °F) (guide) |
| P0705, P0707 and P0708 | Range sensor (guide) |
| P1709 | Kickdown servo switch (A4AF3): on in 2nd or 4th, or off in 1st or 3rd |
Hyundai repeats the same A4AF3 code list in its 2003, 2006 and 2011 Accent manuals. You can look up other codes in our diagnosis by code and see what each dashboard light means.
Test values
| What to measure | Value according to Hyundai |
|---|---|
| Shift solenoids A, B and C | 22.3 ± 1.5 Ω at 20 °C |
| Pressure solenoids A and B and converter solenoid | 2.7 to 3.4 Ω at 20 °C |
| Input and output speed sensors | 245 ± 30 Ω at 20 °C |
| Pressure in N, at idle | 402 to 422 kPa (58 to 61 psi) |
| Pressure in R at 2,500 rpm (front clutch and low and reverse brake) | 1,815 to 1,913 kPa (263 to 277 psi) |
| Band servo pressure in 2nd and 4th, at 2,500 rpm | 853 to 893 kPa (124 to 129 psi) |
| Band pressure adjustment | 860 to 900 kPa (122 to 129 psi); each turn of the regulator screw changes it by about 38 kPa (5.4 psi) |
| Stall speed in D and R | 2,400 to 2,800 rpm, 5 seconds at most |
These are values from Hyundai's service manual for the 2006 Accent 1.6 (US), the same transmission and engine as the 2007 to 2011 Attitude; Hyundai measures pressures with the fluid at 80–100 °C (176–212 °F). For the A4CF1, Kia gives a stall speed of 2,000 to 2,700 rpm; we didn't find its resistances.
Which fluid does it take, and how much?
SP-III. Hyundai calls for SP-III fluid in the A4AF3, 6.1 liters in total, and Kia gives 6.8 liters of SP-III for the A4CF1 in its Soul 1.6, the most likely unit in the 2012 to 2014 Attitude. Don't use SP-IV: Hyundai calls for it in its 6-speeds, not these.
The A4AF3 has a dipstick, and Hyundai checks the level hot, at the HOT mark. The pan has a drain plug and the filter is changed by removing the pan. We didn't find a change interval in Hyundai's documents. For the 2015-on Attitude, which is a CVT, see the Mitsubishi guide.
Attitude transmission myths
- "The Dodge Atos and i10 came with an automatic." The Dodge México spec sheets we checked list them with a 5-speed manual only.
- "The 2012 to 2014 Attitude has the Accent's 6-speed." Dodge México says "4-speed automatic"; the 6-speed was the US Accent's.
- "The 2009 to 2011 Accent already had the A4CF1." Hyundai's code key for that era's Accent 1.6 says A4AF3.
- "The A4AF3 has a separate transmission computer." Hyundai says the engine computer (PCM) includes transmission control.
- "It takes SP-IV." Hyundai calls for SP-III in these 4-speeds; SP-IV is for its 6-speeds.
- "If a solenoid fails, it stays in 2nd." Hyundai locks the A4AF3 in 3rd with shift solenoid A or pressure solenoid A faults.
- "P0748 is the 2007 to 2011 Attitude's pressure solenoid." The A4AF3 uses P0745 and P0775; P0748 belongs to the A4CF.
- "A ratio code means a new transmission." Hyundai says it's mostly a sticking valve or a solenoid: check the fluid, solenoids and sensors first.
How is it diagnosed?
- Check the fluid level and condition hot.
- Read the codes: P0745, P0775 or P1709 means an A4AF3; P0748 or P0765, an A4CF.
- If it's stuck in 3rd, check the transmission's 6-pin connector and measure the solenoids.
- Measure the speed sensors and check the range sensor adjustment.
- Run the stall test in D and R, 5 seconds at most each.
- Run the pressure test with the fluid at 80–100 °C (176–212 °F).
- After a repair, erase and relearn the adaptive values with a scan tool.
If you swap the transmission, make sure it's the one for your year: the A4AF3 and the A4CF1 are different designs and use different filters and parts.
TSS parts for the Attitude and Verna
The A4AF3 and A4CF family page has every TSS part for these units. These are the ones that match the jobs in this guide:
| Problem or job | TSS part |
|---|---|
| A4AF3 filter (Verna and Attitude through 2011) | Plastic and metal filter |
| A4CF filter (2012 to 2014 Attitude) | A4CF1 and A4CF2 filter |
| Pump | A4AF3 pump bushing and pump seal, which TSS lists for the A4AF3 and the A4CF |
| A4AF3 overhaul | Bushing kit and overdrive steel plate |
| A4CF overhaul | Rojo gasket kit: its title says A4CF2, so confirm with Veinte 07 that it fits your unit |
| Automatic Grand i10 | Dorado gasket kit A4CF0 |
TSS A4AF3 bands, pan gasket and overdrive drum kit are out of stock for now, and TSS has no solenoids or sensors for these units. If you're torn between gasket kits, read how they differ.
TSS is an aftermarket brand with OEM-comparable quality and quality control on every product. You can buy it from our authorized distributors: in the United States from Sun Transmissions, and in Mexico the full TSS catalog at Transmisiones Veinte 07.






